D-Link Comprehensive Guide to ADSL BER Test and ADSL Testing Procedures

Page 59

Section 9 - Status

ADSL BER Test

A Bit Error Rate Test (BER Test) is a test that reflects the ratio of error bits to the total number transmitted.

If you click on the ADSL BER Test button at the bottom of the ADSL Statistics page, the following pop-up screen will appear allowing you to set the tested time and to begin the test. Click Start to begin the test.

When you start the ADSL BER Test, the following progress window will display the connection speed as well as the length of time that the test will run for. At any time during the test, click on the Stop button to terminate the test.

D-Link DSL-2540B ADSL2+ 4-Port Router User Manual

59

Image 59

Contents Page Table of Contents Status General Information Package ContentsImportant Safety Instructions DSL LED Front Panel ViewON/OFF Rear Panel ViewConnect the Adsl and Telephone Lines Installing the RouterConnect the Power Adapter Installation Diagram Windows Configuring Your ComputerWindows XP Log in to the Router Wizard HomeHome Home Home Home Home Home WAN Category UBR Without PCR Home Home Enable NAT Enable Firewall Enable Igmp Multicast Home LAN DNS Dynamic DNS Logout Adsl Advanced SetupAdsl Settings Adsl Tone Settings Virtual Server NAT-Virtual Servers SetupAdvanced Setup Advanced Setup DMZ Filter Outbound Outgoing IP Filtering SetupFilter Inbound Incoming IP Filtering SetupAdvanced Setup Bridge Filters MAC Filtering SetupAdvanced Setup Routing Static Route RoutingRIP Quality of Service Advanced Setup Tools AdminTime Remote Log Tools System Save and RebootBackup Settings Restore Default Settings Update SettingsFirmware Test Dhcp Clients StatusDevice Info Route Info WAN InfoLog WAN Adsl Adsl BER Test Status Why can’t I access the web-based configuration utility? TroubleshootingWhat can I do if I forgot my password? Check your IP address Networking BasicsStatically Assign an IP address Contacting Technical Support Warranty Appendix C Warranty Registration