D-Link DSL-2540B manual Connect the Power Adapter

Page 8

Section 2 - Installing The Router

Connect the Power Adapter

•Complete the process by connecting the supplied 12VAC, 1A power adapter to the POWER connector on the back of the device and plug the adapter into a wall outlet or power strip. Then turn on and boot up your PC and any LAN devices, such as hubs or switches, and any computers connected to them.

D-Link DSL-2540B ADSL2+ 4-Port Router User Manual

Image 8

Contents Page Table of Contents Status General Information Package ContentsImportant Safety Instructions Front Panel View DSL LEDRear Panel View ON/OFFInstalling the Router Connect the Adsl and Telephone LinesConnect the Power Adapter Installation Diagram Configuring Your Computer WindowsWindows XP Log in to the Router Home WizardHome Home Home Home Home Home WAN Category UBR Without PCR Home Home Enable NAT Enable Firewall Enable Igmp Multicast Home LAN DNS Dynamic DNS Logout Advanced Setup AdslAdsl Settings Adsl Tone Settings NAT-Virtual Servers Setup Virtual ServerAdvanced Setup Advanced Setup DMZ Outgoing IP Filtering Setup Filter OutboundIncoming IP Filtering Setup Filter InboundAdvanced Setup MAC Filtering Setup Bridge FiltersAdvanced Setup Routing Routing Static RouteRIP Quality of Service Advanced Setup Admin ToolsTime Remote Log Tools System Save and RebootBackup Settings Update Settings Restore Default SettingsFirmware Test Dhcp Clients StatusDevice Info WAN Info Route InfoLog WAN Adsl Adsl BER Test Status Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Networking Basics Check your IP addressStatically Assign an IP address Contacting Technical Support Warranty Appendix C Warranty Registration