D-Link DSL-2540B manual Advanced Setup

Page 39

Section 7 - Advanced Setup

The Add IP Filter screen will appear when you click Add. Enter a filter name, protocol, source address information (from the WAN side) and destination address information (to the LAN side). Select the WAN interface and when ready, click Apply to add the filter.

The following screen appears when you create an IP filter. The screen lists the IP filters that were added from the previous screen. To change your settings, click the Add or Remove buttons.

D-Link DSL-2540B ADSL2+ 4-Port Router User Manual

39

Image 39
Contents Page Table of Contents Status Package Contents Important Safety InstructionsGeneral Information DSL LED Front Panel ViewON/OFF Rear Panel ViewConnect the Adsl and Telephone Lines Installing the RouterConnect the Power Adapter Installation Diagram Windows Configuring Your ComputerWindows XP Log in to the Router Wizard HomeHome Home Home Home Home Home WAN Category UBR Without PCR Home Home Enable NAT Enable Firewall Enable Igmp Multicast Home LAN DNS Dynamic DNS Logout Adsl Advanced SetupAdsl Settings Adsl Tone Settings Virtual Server NAT-Virtual Servers SetupAdvanced Setup Advanced Setup DMZ Filter Outbound Outgoing IP Filtering SetupFilter Inbound Incoming IP Filtering SetupAdvanced Setup Bridge Filters MAC Filtering SetupAdvanced Setup Routing Static Route RoutingRIP Quality of Service Advanced Setup Tools AdminTime Remote Log Tools Save and Reboot Backup SettingsSystem Restore Default Settings Update SettingsFirmware Test Status Device InfoDhcp Clients Route Info WAN InfoLog WAN Adsl Adsl BER Test Status Why can’t I access the web-based configuration utility? TroubleshootingWhat can I do if I forgot my password? Check your IP address Networking BasicsStatically Assign an IP address Contacting Technical Support Warranty Appendix C Warranty Registration