D-Link DWL-810 manual Stations, Static IP Address

Page 17

Web Configuration

Static IP Address

When assigning IP Addresses to the computers on the network, please

remember that the IP Address for each computer must be in the same IP

Address range as all the computers in the network, and the subnet mask

must be exactly the same for all the computers in the network.

For example: If the first computer is assigned an IP Address of 192.168.0.2 with

a Subnet Mask of 255.255.255.0, then the second computer can be assigned an

IP Address of 192.168.0.3 with a Subnet Mask of 255.255.255.0, etc.

IMPORTANT: If computers or other devices are assigned the same IP

Address, one or more of the devices may not be visible on the network.

Bridge Name: The default setting is to leave this field blank. You may enter a name for the DWL-810. This is optional.

Allow Upgrade Uploads: When upgrading firmware, select this checkbox. Deselect this checkbox during normal operation, when not upgrading firmware.

After completing the configuration, click Save to save the changes. Click Cancel to discard the changes.

Changes will take effect after restarting the DWL-810. To restart, click Admin in the menu. Click Reboot to restart the DWL-810.

Stations

Fig. 5.6

Click on Stations in the menu. A Stations table will appear, as shown here, providing information regarding the device connected to the DWL-810.

Bridge Table: the table displays the IP Address and the MAC Address of the device that is wirelessly connected to the DWL-810.

17

Image 17
Contents Air DWL-810 Contents Package Contents Introduction LEDs Features and BenefitsConnections Default SettingsWireless Basics Link Air Wireless Family of LAN products include Wireless BasicsStandards Based Technology Installation ConsiderationsGetting Started Setup #1Getting Started Factory Default Settings for the DWL-810 Web ConfigurationInformation Web ConfigurationWireless Web Configuration Static Select Fig IP AddressStatic IP Address StationsAdmin About InstallationHelp DWL-810 Ethernet-to-Wireless Bridge Power light is not on TroubleshootingDWL-810 Ethernet-to-Wireless Bridge Link light is not on Advanced Setup optionalTechnical Specifications Temperature Physical DimensionsDiagnostic LED Power SpecificationsContacting Technical Support SafetyOperating Channels Link Technical Support over the InternetWhat You Must Do For Warranty Service Warranty and RegistrationWhat Is Not Covered