D-Link DWL-810 manual Installation, Help, About

Page 19

Web Configuration

Help

Fig. 5.8

Click on Help in the menu to see an explanation of the items in the Configuration menu.

About

Fig. 5.9

Click on About in the menu to see the full name of the DWL-810.

6.Installation

After you have configured the DWL-810, or if you are using Ad-Hoc mode, you are ready to connect it to a network device to achieve wireless transmission.

1.Connect one end of a Straight-Through Ethernet Cat5 cable to the Ethernet port on the network device, and connect the other end of the cable to the Ethernet port on the DWL-810.

2.Turn on the power of the network device.

19

Image 19

Contents Air DWL-810 Contents Package Contents Introduction LEDs Features and BenefitsConnections Default SettingsWireless Basics Link Air Wireless Family of LAN products include Wireless BasicsStandards Based Technology Installation ConsiderationsGetting Started Setup #1Getting Started Factory Default Settings for the DWL-810 Web ConfigurationInformation Web ConfigurationWireless Web Configuration Static Select Fig IP AddressStatic IP Address StationsAdmin Help InstallationAbout Advanced Setup optional TroubleshootingDWL-810 Ethernet-to-Wireless Bridge Power light is not on DWL-810 Ethernet-to-Wireless Bridge Link light is not onTechnical Specifications Power Specifications Physical DimensionsTemperature Diagnostic LEDLink Technical Support over the Internet SafetyContacting Technical Support Operating ChannelsWhat You Must Do For Warranty Service Warranty and RegistrationWhat Is Not Covered