D-Link DWL-810 manual Web Configuration

Page 15

Web Configuration

Transmission Rate: Automatic is the default setting. Choose the the transmission rate of the DWL-810 from the pull-down menu.

Access Point Density: This field describes the density of the Access Points and the traffic level of the wireless network running on Infrastructure Mode, which is determined by the number of Access Points in your wireless network and the configuration of the Access Points. Use the pull-down menu to choose from the 3 options: Low, Medium, or High.

WEP Enabled: The default setting is Disable. Wireless network communications are easily intercepted. WEP (Wired Equivalent Privacy) is an encryption method specified by the 802.11b standard to make any intercepted communications extremely difficult to interpret by unauthorized parties. All devices on the network, and the Access Point, must share the same WEP selection – either Enable or Disable

To enable WEP Encryption, click on WEP Enable.

WEP Key Length: The default Key Length is 64-bit.

The WEP key is generated from Hexadecimal entries that are either 64 or 128-bit in length. When enabling encryption, select the Key Length, either 64 or 128-bit, and then input the Hexadecimal digits. You can create up to 4 keys.

Hexadecimal digits consist of the numbers 0-9 and the letters A-F

A64-bit WEP key requires 10 Hexadecimal digits. A 128-bit WEP key requires 26 Hexadecimal digits.

WEP Key to Use: Use the pull-down menu to select the WEP key. All devices on the network must use the same key to communicate with one another. Please be careful when entering WEP values, any input error will result in a communication failure.

Deny Unencrypted Data: By default, this item is not selected. For additional security when WEP is enabled, select Deny Unencrypted Data. Data received without a WEP key is rejected when Deny Unencrypted Data is selected.

15

Image 15
Contents Air DWL-810 Contents Package Contents Introduction LEDs Features and BenefitsConnections Default SettingsWireless Basics Link Air Wireless Family of LAN products include Wireless BasicsStandards Based Technology Installation ConsiderationsGetting Started Setup #1Getting Started Factory Default Settings for the DWL-810 Web ConfigurationInformation Web ConfigurationWireless Web Configuration Static Select Fig IP AddressStatic IP Address StationsAdmin Installation HelpAbout Advanced Setup optional TroubleshootingDWL-810 Ethernet-to-Wireless Bridge Power light is not on DWL-810 Ethernet-to-Wireless Bridge Link light is not onTechnical Specifications Power Specifications Physical DimensionsTemperature Diagnostic LEDLink Technical Support over the Internet SafetyContacting Technical Support Operating ChannelsWhat You Must Do For Warranty Service Warranty and RegistrationWhat Is Not Covered