D-Link DWL-810 manual Technical Specifications

Page 21

The DWL-810 Ethernet-to-Wireless Bridge has a default channel of 6. Make sure that the channel on the DWL-810 Ethernet-to- Wireless Bridge is exactly the same as the channel on the other wireless client.

4.I cannot connect to an access point or wireless router.

The DWL-810 Ethernet-to-Wireless Bridge has a default wireless setting of Ad-hoc. If you are connecting to an access point or wireless router you will need to change that setting to Infrastructure. (See Web Configuration in this manual.)

8.Technical Specifications

Standards:

IEEE 802.11b

IEEE 802.3 Ethernet

Adapter Type:

IEEE 802.3 Ethernet to IEEE 802.11b Wireless

Supported Operating Systems:

Windows XP

Windows 2000

Windows ME

Windows 98

Data Security:

64-bit WEP (Wired Equivalent Privacy) Encryption

128-bit WEP (Wired Equivalent Privacy) Encryption

Data Rate: Mbps

11 : CCK

5.5 : CCK

2 : DQPSK

1 : DBSK

Range:

Indoors – 115 to 328 feet (35 to 100 meters) per cell

Outdoors – 328 feet to 984 feet (100 to 300 meters) per cell

21

Image 21
Contents Air DWL-810 Contents Package Contents Introduction LEDs Features and BenefitsConnections Default SettingsWireless Basics Link Air Wireless Family of LAN products include Wireless BasicsStandards Based Technology Installation ConsiderationsGetting Started Setup #1Getting Started Factory Default Settings for the DWL-810 Web ConfigurationInformation Web ConfigurationWireless Web Configuration Static Select Fig IP AddressStatic IP Address StationsAdmin Installation HelpAbout DWL-810 Ethernet-to-Wireless Bridge Power light is not on TroubleshootingDWL-810 Ethernet-to-Wireless Bridge Link light is not on Advanced Setup optionalTechnical Specifications Temperature Physical DimensionsDiagnostic LED Power SpecificationsContacting Technical Support SafetyOperating Channels Link Technical Support over the InternetWhat You Must Do For Warranty Service Warranty and RegistrationWhat Is Not Covered