NETGEAR Wireless ADSL Modem Router Power LED Not On, Test LED Never Turns On or Test LED Stays On

Page 20

Wireless ADSL Modem Router Setup Manual

b.The LAN port LEDs are lit for any local ports that are connected.

c.The ADSL Internet port LED is lit.

If a port’s LED is lit, a link has been established to the connected device. If a LAN port is connected to a 100 Mbps device, verify that the port’s LED is green. If the port is 10 Mbps, the LED will be amber.

If any of these conditions does not occur, refer to the appropriate following section.

Power LED Not On

If the Power and other LEDs are off when your router is turned on:

•Make sure that the power cord is properly connected to your router and that the power supply adapter is properly connected to a functioning power outlet.

•Check that you are using the power adapter supplied by NETGEAR for this product.

If the error persists, you have a hardware problem and should contact technical support.

Test LED Never Turns On or Test LED Stays On

When the router is turned on, the Test LED turns on for about 10 seconds and then turns off. If the Test LED does not turn on, or if it stays on, there is a fault within the router.

If you experience problems with the Test LED:

•Cycle the power to see if the router recovers and the LED blinks for the correct amount of time.

If all LEDs including the Test LED are still on one minute after power up:

•Cycle the power to see if the router recovers.

•Clear the router’s configuration to factory defaults. This will set the router’s IP address to 192.168.0.1. This procedure is explained in “Using the Reset Button” on page 2-9.

If the error persists, you might have a hardware problem and should contact technical support.

2-2

Troubleshooting

v1.1, 2006-2

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Wireless Adsl Modem Router Setup Manual Trademarks Contents Using the Reset Button Chapter Connecting the Router to the Internet What’s in the Box?Router’s Front Panel LED DescriptionsWhat You Need Before You Begin Router’s Rear PanelTwo Setup Methods 1 Smart Wizard Setup 2 Manual Setup Internet Configuration RequirementsUnderstanding Adsl Microfilters Smart Wizard SetupManual Setup Manually Setting Up Your Wireless Adsl Modem Router Computers Set to DhcpModem router Phone to the filter Wireless Adsl Modem Router Setup Manual Wireless Adsl Modem Router Setup Manual Computer or Preparing a Computer for Network Access Wireless Adsl Modem Router Setup Manual How to Set Up and Test Basic Wireless Connectivity Implement Appropriate Wireless Security Chapter Troubleshooting Basic FunctioningPower LED Not On Test LED Never Turns On or Test LED Stays OnTroubleshooting the Web Configuration Interface LAN or Adsl Internet Port LEDs Not OnTroubleshooting the ISP Connection Adsl linkObtaining an Internet IP Address Adsl Internet LED OffTroubleshooting PPPoE or PPPoA Testing the LAN Path to Your Router Troubleshooting a TCP/IP Network Using the Ping UtilityTroubleshooting Internet Browsing Testing the Path from Your Computer to a Remote Device Request timed outRestoring the Default Configuration and Password Using the Reset ButtonWireless Adsl Modem Router Setup Manual Appendix a Technical Specifications Network Protocol and Standards CompatibilityWireless Adsl Modem Router Setup Manual Appendix B Related Documents Document LinkWireless Adsl Modem Router Setup Manual
Top Page Image Contents