NETGEAR WG302 manual Default Factory Settings, Feature Factory Default Settings

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302

Default Factory Settings

When you first receive your WG302, the default factory settings will be set as shown below. You can restore these defaults with the Factory Default Restore switch on the rear panel — see “WG302 front panel” on page 2-6.

FEATURE	FACTORY DEFAULT SETTINGS
User Name (case sensitive)	admin
Password (case sensitive)	password
Operating Mode	Access Point
Access Point Name	netgearxxxxxx where xxxxxx are the last six
	digits of the wireless access point's MAC address
Built-in DHCP client	DHCP client disabled
Built-in DHCP server	DHCP server disabled
IP Configuration	IP Address: 192.168.0.228
(if DHCP server is unavailable)	Subnet Mask: 255.255.255.0
	Gateway: 0.0.0.0
Network Name (SSID)	NETGEAR
Broadcast Network Name (SSID)	Enabled
802.11g Radio Frequency Channel	11
AutoCell RF Management	Enabled
AutoCell Enhanced RF Security ‘stealth’ mode	Disabled
WEP/WPA	Disabled
Restricting connectivity based on MAC Access	Disabled
Control List
Spanning Tree Protocol	Enabled
Time Zone	GMT
Time Zone Adjust for Daylight Saving TIme	Disabled
SNMP	Enabled but Trap forwarding is disabled
Secure Telnet	Enabled
SugerG Mode	Disabled
WMM Mode	Disabled

Basic Installation and Configuration 3-3

July 2005 v3.0