ArtDio IPS-2101h user manual NAT Addr, Phone Number Account, Register Port Signal Port

Page 15

NAT Addr

NAT TTL

Phone Number

Account

PIN

Register Port

Signal Port

IPS-2101h User Manual

SIP traverse the NAT. If this option is selected, please also enter the IP address of the STUN server in the NAT Addr field.

When “Enable” or “STUN” is selected in the NAT Traversal field, enter the NAT Proxy’s IP address in this field. Otherwise, keep this field as 0.0.0.0. Define how many seconds a NAT traversal message will be sent to the NAT server. The default setting is 30 seconds, and the maximum is 254. With H.323/MGCP/SIP protocol used, enter the phone number of the IPS-2101h.

zWhen using H.323 protocol to logon a Gatekeeper, please enter the H.323 ID or H.235 account in this field.

zWhen “Prefix” is selected in the Use Dialplan field, please enter the number provided by ISR, card number and “#” in this field. For example: 14589653185#

zWith MGCP protocol used, please enter the Local name of the EndpointID into this field.

zWith SIP protocol used, enter your SIP Proxy account in this field.

zWhen H.323 protocol is used to logon the Gatekeeper, enter the password or H.235 authentication password in this field.

zWhen SIP protocol is used to logon the SIP Proxy Server, please enter the password into this field.

zWhen select “Prefix” in the Use Dialplan drop-down list, please enter the password provided by ISR, card number, and end with a “#” key. For example 3185#.

zWith MGCP protocol used, enter the domain name of the EndpointID into this field.

With MGCP protocol is used, as requested by some system, please

add the bracket with the domain name into this field. For example, [voiptest.com].

According to used protocol, configure the service port as follows:

With H.323 protocol used:

ƒIf a Gatekeeper is used, the register port works as the gatekeeper’s monitor port. The default value is 1719.

ƒIf a Gatekeeper is not used, the register port works as the end point device or the gatekeeper’s monitor port. The default value is 1720.

With MGCP protocol used, this port is the Call Agent’s receive port. The default value is 2727.

With SIP protocol used, the default value is 5060.

With H.323 protocol used, this port is mapped to the Q.931 port. For H.323, the Q.931 call usually uses TCP protocol. The value can be set from 1024 to 65535.

15

Image 15
Contents V1.0 Safety Instructions Passing Through the NAT/Firewall Hardware InstallationNetwork Settings Using Status Button on IPS-2101h WEB Configuration11.4 Phone Interface Product SpecificationsVoice Interface LAN InterfacePackage Content InstallationFunctions Status Indicator Functions Status Button FunctionsLight Connection with an IP Sharing Device or a Router Hardware InstallationConnection without an IP Sharing Device or a Router Network Settings Using Status Button on IPS-2101h Static IP SettingsDhcp Settings PPPoE Settings IP Type WEB ConfigurationNetwork Settings Fields DescriptionProtocol Settings Page Register Port Signal Port NAT AddrPhone Number Account Phone Settings Control port Register TTLRTP Port Local Type Call Type DDD Code Dual ModeUse Dialplan Dial NumberAudio Settings Update Other SettingsPassing Through the NAT/Firewall SIP with StunSIP with Outbound Proxy Pickup the Phone Using IPS-2101hRegistration Message OthersOther Phone Operation Firmware Auto-upgradeAppendix 11.1 H.323 Web Configuration ExampleMgcp Web Configuration Example Update Information How to Add a Prefix in Front of the NumberLos Angeles Office, U.S.A