ArtDio Registration Message, Using IPS-2101h, Others, Pickup the Phone, Making Phone Calls

Page 21

IPS-2101h User Manual

7.3Others

With H.323 or MGCP protocol is used, please refer to the appendix H.323 and MGCP configuration examples. If IPS-2101h can not work this way, open the corresponding ports on your NAT/Firewall device.

Figure below shows the possible usage ports for the IPS-2101h. Please contact to the network administrator or MIS person to open these ports on the NAT/Firewall device:

zRegister portFor TCP/UDP protocol.

zSignal portFor TCP/UDP protocol.

zControl portFor TCP/UDP protocol.

zRTP portFor UDP protocol.

8. Registration Message

Once the account is successfully registered on the IPS-2101h, the light on Status Button will turn off. Normally it takes 10 seconds to register, and 20 seconds to reboot. If the Status Button keep blinking red light more than one minute, please check your internet connection, network and account configuration. If it still doesn’t work, please contact your reseller.

9. Using IPS-2101h

9.1Pickup the Phone

The IPS-2101h will ring when there is an incoming phone call, either the IP call or PSTN calls.

9.2Making Phone Calls

zTo make a IP call (the default Dual Mode setting for IPS-2101h is the “IP first”):

Pick up the handset, after hearing the dial tone, you can proceed to dial the phone number and end with a # key to dial out the phone number. (Or wait for about 4 seconds instead

of the # key.) Once you hear long “Du Du” tone, the other end is ringing.

zTo make a PSTN (traditional) call:

Pick up the handset and press the Dualmode Prefix you have configured to switch to the PSTN line. After hearing the dial tone, you can proceed to dial the phone number. Once you hear long “Du Du” tone, the other end is ringing.

zTo make a call when blackout:

During blackout, IP call can not be made and IPS-2101h will switch to PSTN mode. To make a PSTN call in this kind of situation, simply pick up the phone and dial the phone number as the traditional phone.

If you hear a busy tone after you dial, the other end is using the phone. Please hang up and make the call later.

21

Image 21
Contents V1.0 Safety Instructions Network Settings Using Status Button on IPS-2101h Hardware InstallationWEB Configuration Passing Through the NAT/Firewall11.4 Voice Interface Product SpecificationsLAN Interface Phone InterfacePackage Content InstallationFunctions Status Indicator Functions Status Button FunctionsLight Connection with an IP Sharing Device or a Router Hardware InstallationConnection without an IP Sharing Device or a Router Network Settings Using Status Button on IPS-2101h Static IP SettingsDhcp Settings PPPoE Settings Network Settings WEB ConfigurationFields Description IP TypeProtocol Settings Page Register Port Signal Port NAT AddrPhone Number Account Phone Settings Control port Register TTLRTP Port Local Type Call Type Use Dialplan Dual ModeDial Number DDD CodeAudio Settings Update Other SettingsPassing Through the NAT/Firewall SIP with StunSIP with Outbound Proxy Registration Message Using IPS-2101hOthers Pickup the PhoneOther Phone Operation Firmware Auto-upgradeAppendix 11.1 H.323 Web Configuration ExampleMgcp Web Configuration Example Update Information How to Add a Prefix in Front of the NumberLos Angeles Office, U.S.A