EtherFast Cable/DSL Router with 8-Port Switch
•Incoming Log. Click the Incoming Log button to view a temporary log of the Source IP addresses and Destination Port Numbers for all the incoming Internet traffic. Click the Refresh button to update the log. See Figure
•Outgoing Log. Click the Outgoing Log button to view a temporary log of all the URLs and IP addresses of Internet sites that users on your network have accessed. The LAN IP address, Destination URL/IP, and Service/Port Number for each site are listed. Click the Refresh button to update the log. See Figure
•View Log. Click the View Logs button to display a log of all activities and to access a
From the
•Clear. To clear a log, click the Clear button.
•Refresh. To update a log, click the Refresh button.
When finished making your changes on this tab, click the Save Settings button to save these changes, or click the Cancel Changes button to undo your changes. For further help on this tab, click the Help button.
Factory Defaults
The Factory Defaults screen, shown in Figure
Factory Defaults
Note: Do not restore the factory defaults unless you are having difficulties with the Router and have exhausted all other troubleshooting measures. Once the Router is reset, you will have to
•Restore Factory Defaults. To clear all of the Router’s settings and reset them to its factory defaults, click the Yes radio button.
When finished making your changes on this tab, click the Save Settings button to save these changes, or click the Cancel Changes button to undo your changes. For further help on this tab, click the Help button.
Chapter 7: Using The Router’s
Figure 7-25: Incoming Log Table
Figure 7-26: Outgoing Log Table
Figure 7-27: System Log
Figure 7-28: Factory Defaults
36
Factory Defaults