Linksys BEFSR81 manual How can I check whether I have static or Dhcp IP addresses?

Page 58

EtherFast Cable/DSL Router with 8-Port Switch

What is the maximum number of VPN sessions allowed by the Router?

The maximum number depends on many factors. At least one IPSec session will work through the Router; however, simultaneous IPSec sessions may be possible, depending on the specifics of your VPNs.

How can I check whether I have static or DHCP IP addresses?

Ask your ISP to find out.

How do I get mIRC to work with the Router?

Under the Applications & Gaming => Port Range Forwarding tab, set port forwarding to 113 for the PC on which you are using mIRC.

If your questions are not addressed here, refer to the Linksys website, www.linksys.com.

Appendix A: Troubleshooting

52

Frequently Asked Questions

Image 58

Contents Cable/DSL Router Copyright and Trademarks How to Use this GuideWord definition Table of Contents Appendix B Upgrading Firmware Appendix a TroubleshootingCommon Problems and Solutions Frequently Asked Questions Ethernet AdapterList of Figures Back PanelDdns Disabled Introduction WelcomeWhat’s in this Guide? EtherFast Cable/DSL Router with 8-Port Switch An Introduction to LANs Networking BasicsUse of IP Addresses Networking Basics Use of IP Addresses Reset Button Reset button can be used in one of two ways Getting to Know the RouterFront Panel Connecting the Router OverviewConnection Instructions Connect a PCConfiguring the PCs Configuring Windows 98 and Millennium PCsConfiguring Windows 2000 PCs Configuring Windows XP PCsInternet Protocol TCP/IP for Windows XP Configuring the Router InstructionsObtain an IP Automatically or Dhcp Static IPPPPoE RASHeart Beat Signal PptpNavigating the Utility Using The Router’s Web-based UtilitySetup SecurityApplications & Gaming Quick and Easy AdministrationAdministration StatusBasic Setup Internet SetupRAS for SingTel PPPoEHeart Beat Signal PptpOptional Settings Network SetupRouter IP Network Address Server Settings Dhcp DdnsDynDNS.org MAC Address CloneTZO.com Advanced Routing MAC CloneFilter 14 Routing TableFilter MAC Address Filter IP Address RangeFilter Port Range Block WAN RequestsPort Range Forwarding VPN PassthroughPort Range Triggered Range Port TriggeringForwarded Range UPnP Forwarding 20 UPnP ForwardingDMZ QoS QoSApplication-based QoS Management Router AccessLocal Router Access Port-based QoSRemote Router Access IdentificationLog UPnPFactory Defaults 25 Incoming Log TableRouter Firmware UpgradeUpgrade Firmware InformationLocal Network 31 Local NetworkFor Windows 98 and Millennium Appendix a TroubleshootingCommon Problems and Solutions For WindowsFor Windows XP For Windows 98 and Millennium EtherFast Cable/DSL Router with 8-Port Switch Am not able to access the Router’s Web-based Utility Setup Need to set up a server behind my RouterApplication Start and End Protocol IP Address Enabled TCPCan’t get the Internet game, server, or application to work For Microsoft Internet Explorer 5.0 or higher To start over, I need to set the Router to factory defaultNeed to upgrade the firmware For Netscape 4.7 or higherFirmware upgrade failed My DSL service’s PPPoE is always disconnectingNeed to use port triggering Is IPSec Passthrough supported by the Router? Frequently Asked Questions Where is the Router installed on the network? Does the Router support IPX or AppleTalk?How can I block corrupted FTP downloads? Is the Router cross-platform compatible? What is DMZ Hosting?Will the Router function in a Macintosh environment? How many ports can be simultaneously forwarded?How can I check whether I have static or Dhcp IP addresses? How do I get mIRC to work with the Router?Figure B-1 Upgrade Firmware Appendix B Upgrading FirmwareWindows 98 or Me Instructions Windows 2000 or XP InstructionsFor the Router’s Web-based Utility Figure C-3 MAC Address/Physical AddressShared Resources Appendix D Windows HelpNetwork Neighborhood/My Network Places Appendix E Glossary EtherFast Cable/DSL Router with 8-Port Switch EtherFast Cable/DSL Router with 8-Port Switch EtherFast Cable/DSL Router with 8-Port Switch EtherFast Cable/DSL Router with 8-Port Switch EtherFast Cable/DSL Router with 8-Port Switch Standards Appendix F SpecificationsEight 10/100 RJ-45 Switched Ports PortsAppendix G Warranty Information Limited WarrantyAppendix H Regulatory Information FCC StatementNeed to contact Linksys? Appendix I Contact InformationInformation section in this Guide

Related manuals

Manual 26 pages 4.32 Kb