Linksys BEFW11S4 manual Security, AOL Parental Controls

Page 21

Instant Wireless® Series

Security

Figure 5-12

The Security tab, as shown in Figure 5-12, enables configuration of the Router to provide parental controls.

AOL Parental Controls

Click on the radio button next to Enable to use AOL’s “Parental Controls” feature. Enabling this will disable all options under the Advanced tab except MAC Address cloning, and will disable all Internet access, except when using AOL client software. Click the radio button next to Disable if you don’t want to use this feature.

Note: AOL Parental Controls are available to AOL customers in the United States only.

Wireless Access Point Router with 4-Port Switch

If at any time you enable the AOL Parental Controls feature in the Router, you must run the Setup Wizard CD and select Setup Additional Computer(s) to install the AOL 7.0 software on your computers.

To apply the settings that you change on a page, click the Apply button. To can- cel any values you’ve entered on a page, click the Cancel button.

33

34

Image 21

Contents Wireless Access Point Router With 4-Port Switch Copyright & Trademarks Industry Canada Canada Table of Contents Features Linksys Wireless Access Point Router with 4-Port SwitchIntroduction Minimum RequirementsIP Addresses Dhcp Dynamic Host Configuration Protocol ServersWhat’s an IP Address? Static IP AddressesPower Wireless Access Point Router’s PortsWireless Access Point Router’s LEDs PortsWAN Indicators Connecting the RouterConnecting Your Hardware Together and Booting Up Before You StartInstant Wireless Series Configuring the PCs Configuring Windows 95, 98, and Millennium PCsOverview Configuring Windows 2000 PCs Configuring Windows XP PCs A b l e / D i s a b l e Configuring the RouterStatic IP Obtain an IP AutomaticallyAddress PPPoEPptp Using the Router’s Web- Based UtilitySetup Static IP Status PasswordDhcp Log AOL Parental Controls SecurityFilters HelpEditing MAC Filter Setting Setting Up FiltersUsing Multicast Pass Through Advanced Tab FiltersUsing Pptp Pass Through Using IPSec Pass ThroughUsing Remote Management Using Remote UpgradeAdvanced Tab Port Range Forwarding UPnP ForwardingInstant Wireless Series Advanced Tab Dynamic Routing Port TriggeringAdvanced Tab Static Routing Advanced Tab MAC Address Cloning Advanced Tab DMZ HostAdvanced Tab Wireless Appendix a Troubleshooting Common Problems and SolutionsNeed to set a static IP address on a PC For Windows XP For Windows NTWant to test my Internet connection For Windows 95, 98, and MeFor Windows XP Need to set up a server behind my Router Am not able to access the Router’s web interface SetupCan’t get the Internet game, server, or application to work Need to upgrade the firmware To start over, I need to set the Router to factory defaultFirmware upgrade failed, and/or the Diag LED is flashing My DSL service’s PPPoE is always disconnectingNeed to use port triggering Click the Advanced = Filter tabDiag LED stays lit continuously Full/Col LED keeps flickering continuouslyFrequently Asked Questions Allows Pptp packets to pass through Instant Wireless Series Appendix B How to Ping Your ISP’s E-mail and Web Addresses Step One Pinging an IP AddressStep Two Pinging for a Web Address Appendix C Configuring Wireless Security Figure C-2 Figure C-3 Configuring Wireless Security in Windows XPFigure C-6 Figure C-10 For Windows NT, 2000, and XP Figure D-3Http//192.168.1.1 in the web Figure D-6AOL Broadband via DSL Figure E-3Appendix F Glossary Instant Wireless Series Instant Wireless Series Instant Wireless Series 100 102 104 Environmental Appendix G SpecificationsAppendix H Warranty Information Appendix I Contact InformationWeb site FTP site Copyright 2003 Linksys, All Rights Reserved