Linksys BEFW11S4 manual Figure C-6

Page 45

Instant Wireless® Series

If a “Connect to Wireless Network” window appears, in the Available Networks section, click the desired wireless network, specified by the Router’s SSID. Then, double-click the Wireless Network Connection icon.

Figure C-6

5.When the “Wireless Network Connection Status” window appears, as in Figure C-7, click the Properties button.

Figure C-7

Wireless Access Point Router with 4-Port Switch

6.When the “Wireless Network Connection Properties” window appears, as in Figure C- 8, click the Wireless Networks Tab.

Figure C-8

7. If the appropriate wire- less network, specified by the Router’s SSID, is displayed in the “Preferred networks” section, as shown in Figure C-9, double- click it and continue to the next step.

Otherwise, click on the appropriate wireless network, specified by the Router’s SSID, in the “Available net- works” section. Then, click the Configure button

Figure C-9

81

82

Image 45

Contents Wireless Access Point Router With 4-Port Switch Copyright & Trademarks Industry Canada Canada Table of Contents Features Linksys Wireless Access Point Router with 4-Port SwitchIntroduction Minimum RequirementsIP Addresses Dhcp Dynamic Host Configuration Protocol ServersWhat’s an IP Address? Static IP AddressesPower Wireless Access Point Router’s PortsWireless Access Point Router’s LEDs PortsWAN Indicators Connecting the RouterConnecting Your Hardware Together and Booting Up Before You StartInstant Wireless Series Configuring the PCs Configuring Windows 95, 98, and Millennium PCsOverview Configuring Windows 2000 PCs Configuring Windows XP PCs A b l e / D i s a b l e Configuring the RouterStatic IP Obtain an IP AutomaticallyAddress PPPoEPptp Using the Router’s Web- Based UtilitySetup Static IP Status PasswordDhcp Log AOL Parental Controls SecurityFilters HelpEditing MAC Filter Setting Setting Up FiltersUsing Multicast Pass Through Advanced Tab FiltersUsing Pptp Pass Through Using IPSec Pass ThroughUsing Remote Management Using Remote UpgradeAdvanced Tab Port Range Forwarding UPnP ForwardingInstant Wireless Series Advanced Tab Dynamic Routing Port TriggeringAdvanced Tab Static Routing Advanced Tab MAC Address Cloning Advanced Tab DMZ HostAdvanced Tab Wireless Appendix a Troubleshooting Common Problems and SolutionsNeed to set a static IP address on a PC For Windows XP For Windows NTWant to test my Internet connection For Windows 95, 98, and MeFor Windows XP Need to set up a server behind my Router Am not able to access the Router’s web interface SetupCan’t get the Internet game, server, or application to work Need to upgrade the firmware To start over, I need to set the Router to factory defaultFirmware upgrade failed, and/or the Diag LED is flashing My DSL service’s PPPoE is always disconnectingNeed to use port triggering Click the Advanced = Filter tabDiag LED stays lit continuously Full/Col LED keeps flickering continuouslyFrequently Asked Questions Allows Pptp packets to pass through Instant Wireless Series Appendix B How to Ping Your ISP’s E-mail and Web Addresses Step One Pinging an IP AddressStep Two Pinging for a Web Address Appendix C Configuring Wireless Security Figure C-2 Figure C-3 Configuring Wireless Security in Windows XPFigure C-6 Figure C-10 For Windows NT, 2000, and XP Figure D-3Http//192.168.1.1 in the web Figure D-6AOL Broadband via DSL Figure E-3Appendix F Glossary Instant Wireless Series Instant Wireless Series Instant Wireless Series 100 102 104 Environmental Appendix G SpecificationsAppendix H Warranty Information Appendix I Contact InformationWeb site FTP site Copyright 2003 Linksys, All Rights Reserved