Linksys AM200 manual Appendix F Regulatory Information, FCC Statement

Page 43

ADSL Modem

Appendix F: Regulatory Information

FCC Statement

This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment or devices

Connect the equipment to an outlet other than the receiver's

Consult a dealer or an experienced radio/TV technician for assistance

Safety Notices

Caution: To reduce the risk of fire, use only No.26 AWG or larger telecommunication line cord.

Do not use this product near water, for example, in a wet basement or near a swimming pool.

Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

Industry Canada (Canada)

This device complies with Canadian ICES-003 rule.

Cet appareil est conforme à la norme NMB-003 d'Industry Canada.

EC Declaration of Conformity (Europe)

In compliance with the EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC, and Amendment Directive 93/68/EEC, this product meets the requirements of the following standards:

EN55022 Emission

EN55024 Immunity

Appendix F: Regulatory Information

38

Image 43
Contents Adsl Modem Copyright and Trademarks Table of Contents Front Panel Back Panel23 NAT Mapping Table Welcome IntroductionWhat’s in this Guide? DSL Getting to Know the Adsl ModemFront Panel Wall-Mount Option Setting Up and Connecting the Adsl ModemConnecting the Modem OverviewEthernet Connection Applications & Gaming Configuring the Adsl ModemSetup SecurityStatus AdministrationAdsl Settings Basic SetupStatic IP RFC 1483 Bridged Dynamic IPRFC 1483 Routed RFC 2364 PPPoA RFC 2516 PPPoEOptional Settings required by some ISPs Bridged Mode OnlyNetwork Setup DynDNS.org Time SetupTZO.com 12 Advanced Routing Advanced RoutingFirewall Access ControlFilter Table Schedule RuleMAC Filter ControlIntrusion Detection URL BlockingAlert Port Range Forwarding Applications and Gaming TabNAT Mapping Table Port TriggeringSnmp Community ManagementLog Snmp Trap30 Diagnostic Tests DiagnosticsFactory Defaults Firmware UpgradeReboot DSL Status ModemLocal Network Modem InformationCommon Problems and Solutions Appendix a TroubleshootingAdsl Modem To start over, I need to set the Modem to factory default Power LED flashes continuously Frequently Asked QuestionsIs the Modem cross-platform compatible? Appendix B Upgrading Firmware Firmware UpgradeAppendix C Glossary Adsl Modem Adsl Modem Adsl Modem Adsl Modem CE, UL, FCC Appendix D SpecificationsAppendix E Warranty Information FCC Statement Appendix F Regulatory InformationAdsl Modem Adsl Modem Adsl Modem Adsl Modem Adsl Modem Europe Mail Address Appendix G Contact InformationOutside of Europe Mail Address