Multiquip STX55Y6 operation manual Transporting, Towing Safety Precautions, Battery

Page 16

STX-SERIES — RULES FOR SAFE OPERATION

Transporting

ALWAYS shutdown engine before transporting.

Tighten fuel tank cap securely and close fuel petcock to prevent fuel from spilling.

Drain fuel when transporting trowel for long distances or over bad roads.

When placing the trowel on a truck-bed for transport, always tie-down the trowel.

If the trowel is being transported via a trailer, make sure the trailer complies with all local and state safety transportation laws. Refer to the following "Towing Safety Precautions" for basic towing techniques.

Towing Safety Precautions

CAUTION

Conform to Department of Transportation (DOT) Safety Towing Regulations before transporting trowel on public roads.

To reduce the possibility of an accident while transporting the trowel on public roads, always make sure the trailer that supports the trowel and the towing vehicle are in good operating condition and both units are mechanically sound.

The following list of suggestions should be used when towing your trowel:

Make sure the hitch and coupling of the towing vehicle are rated equal to, or greater than the trailer "gross vehicle weight rating" (GVWR) of 6,000 lbs.

ALWAYS inspect the hitch and coupling for wear. NEVER tow a trailer with defective hitches, couplings, chains, etc.

Check the tire air pressure on both towing vehicle and trailer. Trailer tires should be inflated to 50 psi cold. Also check the tire tread wear on both vehicles.

ALWAYS make sure the trailer is equipped with "Safety Chains ".

ALWAYS attach trailer's safety chains to towing vehicle properly.

ALWAYS make sure the vehicle and trailer directional, backup, brake, and trailer lights are connected and working

DO NOT exceed the recommended highway speed when towing. Unless posted otherwise, do not exceed 45 MPH highway, and 10 MPH off-road.

Use chock-blocks at each wheel when parked to prevent trailer from rolling.

Use the trailer's swivel jack to adjust the trailer height to a level position while parked.

Avoid sudden stops and starts. This can cause the trailer to skid or jack-knife. Smooth, gradual starts and stops will improve towing.

Avoid sharp turns.

Trailer should be adjusted to a level position at all times when towing.

Raise and lock trailer wheel stand in the "UP" position when transporting.

DOT requirements include the following: Connect and test electric brake operation.

Secure portable power cables in cable tray with tie wraps.

Battery

The battery contains acids that can cause injury to the eyes and skin. To avoid eye irritation, always wear safety glasses or face shielding. Use well insulated gloves when picking the battery up. Use the following guidelines when handling the battery.

DO NOT drop the battery. Any impact to the battery may cause it to explode.

DO NOT expose the battery to open flames, sparks, lit cigarettes etc. The battery contains combustible gases and liquids. If these gases and liquids come in contact with a flame or spark an explosion can occur.

ALWAYS keep the battery charged. If the

battery is not charged a buildup of combustible gas will occur.

ALWAYS keep battery cables in good working condition. Repair or replace all worn cables.

ALWAYS disconnect the negative battery terminal before performing service on the trowel.

ALWAYS recharge the battery in a vented air environment to avoid risk of a dangerous concentration of combustible gases.

In case the battery liquid, (dilute sulfuric acid), comes in contact with clothing or skin, rinse skin or clothing immediately with plenty of water.

In case the battery liquid, (dilute sulfuric acid), comes in contact with your eyes, rinse eyes immediately with plenty of water, then contact the nearest doctor or hospital and seek medical attention.

PAGE 16 — STX-SERIESRIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #0 (03/15/06)

Image 16
Contents STX RIDE-ON Power Trowel STX55Y6 Page Page Page Heres HOW to GET Help STX-SERIES Table of Contents Best Deal! Order via Internet Dealers Only Order via Fax Dealers OnlySTX-SERIES Dimensions See Notes NextLube Oil Capacity This value includes the seat heightSTX-SERIES Training Checklist Training ChecklistSTX-SERIES Daily PRE-OPERATION Checklist Daily PRE-OPERATION ChecklistSTX-SERIES Safety Message Alert Symbols You can be Injured if you do not follow these directionsAlways wear approved respiratory protection Always wear approved eye and hearing protectionDo not operate or service this SafetyFatigue, illness or taking medicine Additional Safety Information STX-SERIES Rules for Safe OperationAlways keep the work area well organized Order Form PT-160Towing Safety Precautions Secure portable power cables in cable tray with tie wrapsBattery Always keep the battery charged. IfEmergencies Maintenance SafetyAlways know the location of the nearest first aid kit Intended Use Engine BladesHydraulic Motor Hydraulic SteeringMachine Safety Decals STX-SERIES DecalsSTX-SERIES Controls and Indicators Toolbox Compartment Storage for toolsSTX-SERIES Controls and Indicators STX-SERIES Basic Engine Information Accelerator systemOil in crankcase Fuel Return Hose Provides fuel to the fuel injection pumpSTX-SERIES Trowel Setup Trowel SetupSeat Assembly Battery SetupSTX-SERIES PRE-INSPECTION PRE-INSPECTIONEngine Oil Hydraulic OilSTX-SERIES Initial START-UP FuelInitial START-UP Starting the EngineSTX-SERIES Initial START-UP Engine Throttle Control Lever LowSTX-SERIES Operation OperationSteering Palm Handle Forward ReverseTrowel Speed Limiter Control STX-SERIES OperationSpeed limiter control located on the control panel Figure Blade Pitch Control Engine Shut-DownFailure to allow the engine to idle Left Pitch all the way DownSTX-SERIES Maintenance MaintenancePrecleaner Service Air Cleaner DailyRemove the air cleaner element Clean the inside of the dust panMake sure the correct depth air Changing Engine Oil And FilterOil Filter 100 Hours Fuel Filter 200 HoursSTX-SERIES Maintenance Battery/Charging SystemRadiator/Cooling System Long Term StorageMaintenance Procedures Checking/Adjusting Trowel SpeedLeft Side Trowel Speed Adjustment Pump Actuation Levers Connecting RodSTX-SERIES Maintenance Matching Blade Pitch for Both Sets of BladesStabilizer Ring Removal Hex Cap Screw Lock Washer Rod End Hex Nut Stabilizer RingChanging a Blade Trowel Blade RemovalChecking Trowel Arm Straightness Bronze BushingsTrowel Arm Adjustment Locate the trowel arm adjustment tool P/NAdjustment Bolt Distance Locking Nut Fixture Arm SideviewRe-Assembly Checking Hydraulic Pressure Pressure Gauge Hydraulic PumpSteering Pressure Adjustment Checking Steering PressurePitch Pressure Out of Specification Pitch Pressure CheckInstalling Pans Onto Finisher Blades Decommissioning Trowel/ComponentsSTX-SERIES Troubleshooting TroubleshootingSTX-SERIES Troubleshooting Lights optional not working Lights?Page Payment Terms Your Local Dealer is Multiquip INC
Related manuals
Manual 64 pages 22.72 Kb

STX55Y6 specifications

The Multiquip STX55Y6 is a state-of-the-art, high-performance compact excavator designed to tackle a variety of jobs in landscaping, construction, and industrial applications. Built with the operator in mind, this machine combines powerful performance, advanced technology, and exceptional maneuverability in tight spaces.

One of the defining features of the STX55Y6 is its robust engine, which delivers powerful performance while ensuring efficiency and reliability. The excavator is equipped with a 55 horsepower, tier 4-compliant diesel engine that meets stringent emissions standards. This not only contributes to environmental sustainability but also provides ample power for demanding tasks.

The STX55Y6 boasts a compact design with a width of just 39 inches, allowing it to easily navigate through narrow passages and tight job sites. Despite its small footprint, it does not compromise on performance, offering a digging depth of up to 10 feet and a maximum reach of 16.2 feet. This makes it an ideal choice for digging trenches, grading, and other excavation tasks.

Another highlight of the STX55Y6 is its advanced hydraulic system, which provides excellent control and precision during operation. The machine features a powerful hydraulic pump that delivers superior lifting and digging capabilities. Furthermore, the auxiliary hydraulic system allows for the attachment of various implements, such as buckets, breakers, and augers, enhancing the versatility of the machine.

Operator comfort is enhanced through a spacious cab that features adjustable seating, advanced visibility, and intuitive controls. The large, multifunction display provides crucial information at a glance, allowing operators to monitor performance and quickly adapt to changing job site conditions.

Durability is a hallmark of the STX55Y6, with a robust frame and reinforced undercarriage designed to withstand the rigors of daily use. This ensures longevity and reduces maintenance costs, making it a wise investment for any construction or landscaping operation.

In conclusion, the Multiquip STX55Y6 offers an impressive blend of power, versatility, and operator comfort. Its reliable engine, advanced hydraulic system, and compact design make it an essential tool for tackling a variety of excavation tasks efficiently and effectively. With its focus on performance and user experience, this excavator is perfectly suited for today's demanding job sites.