Airlink101 N300 user manual AP Bridge Point to Multi-Point Mode

Page 28

You can click “Continue” to back to previous setup page to continue on other setup procedures, or click “Apply” to reboot the router so the settings will take effect (Please wait for 30 seconds while router is rebooting).

2.4.4 AP Bridge - Point to Multi-Point Mode

In this mode, this wireless access point will connect to up to four wireless access points which uses the same mode, and all wired Ethernet clients of every wireless access points will be connected together. You can use this mode to connect a network to other networks which is physically isolated.

Please note that when you set your access point to this mode, it will not accept regular wireless clients anymore.

Diagram 4: Point to Multi‐Point Bridge mode application

When you select ‘AP Bridge-Point to Multi-Point’, the following options will be displayed:

27

Image 28

Contents

User’s Manual Federal Communication Commission Interference Statement Table of Contents Features Package ContentsAccess Point Interface Local Area Network LAN ports 1 to Configuring the Access Point Installing the Access Point to Your NetworkConnect the AP to the Router Power on the AP Page Access Point Universal Repeater AP Client Point-to-Point / Point-to-MultiPoint / WDS Bridge Page Click Finish to end the EZ Setup Wizard Accessing the Access Point by Web Browser Basic SettingsEssid View System Status and InformationBssid Page Select an Operating Mode for Access Point AP Mode Diagram 1 AP mode applicationMultiple Essid Ssid Please Note That Essid is Case SensitiveWMM AP Client ModeVlan ID Please Note That Essid is Case Sensitive 421 Wireless Site Survey AP Bridge Point to Point Mode Diagram 3 Point to Point Bridge mode applicationPage AP Bridge Point to Multi-Point Mode Diagram 4 Point to Multi‐Point Bridge mode applicationPage AP Bridge WDS Mode Diagram 5 WDS Bridge mode application Main EssidUniversal Repeater Diagram 5 Repeater mode application Main Ssid Configure Wireless Security 1 WEP Page WPA Pre-Shared Key WPA Radius4 802.1x Authentication MD5/PEAP RadiusExternal Radius server. If you check this box, the value Set Up MAC Filtering Page Configure Advanced Settings WMM Configure WPS Setting Page Configure Radius Server Page Management Change the password of the APChange the IP Address of the AP Backup and Restore the Configuration Settings ToolsPage Upgrade the Firmware for the Access Point Reboot the Access Point Troubleshooting Appendix a Specification Technical Support