Airlink101 N300 user manual Reboot the Access Point

Page 53

2.11.3 Reboot the Access Point

When you think the access point is not working properly, you can use this function to restart the access point; this may help and solve the problem.

This function is useful when the access point is far from you or unreachable. However, if the access point is not responding, you may have to switch it off by unplug the power plug and plug it back again after 10 seconds.

To reset your access point, please click ‘Tools’ on the left menu, and the following page will be displayed:

Please click ‘Reboot’ button, and a popup message will ask you again, to make sure you really want to reboot the access point:

Click ‘OK’ to restart the access point, or click ‘Cancel’ to abort. Please remember all connections between wireless client and this access point will be disconnected.

52

Image 53

Contents

User’s Manual Federal Communication Commission Interference Statement Table of Contents Package Contents FeaturesAccess Point Interface Local Area Network LAN ports 1 to Installing the Access Point to Your Network Configuring the Access PointConnect the AP to the Router Power on the AP Page Access Point Universal Repeater AP Client Point-to-Point / Point-to-MultiPoint / WDS Bridge Page Click Finish to end the EZ Setup Wizard Basic Settings Accessing the Access Point by Web BrowserBssid View System Status and InformationEssid Page Select an Operating Mode for Access Point Diagram 1 AP mode application AP ModeMultiple Essid Please Note That Essid is Case Sensitive SsidVlan ID AP Client ModeWMM Please Note That Essid is Case Sensitive 421 Wireless Site Survey Diagram 3 Point to Point Bridge mode application AP Bridge Point to Point ModePage Diagram 4 Point to Multi‐Point Bridge mode application AP Bridge Point to Multi-Point ModePage AP Bridge WDS Mode Main Essid Diagram 5 WDS Bridge mode applicationUniversal Repeater Diagram 5 Repeater mode application Main Ssid Configure Wireless Security 1 WEP Page WPA Radius WPA Pre-Shared KeyMD5/PEAP Radius 4 802.1x AuthenticationExternal Radius server. If you check this box, the value Set Up MAC Filtering Page Configure Advanced Settings WMM Configure WPS Setting Page Configure Radius Server Page Change the IP Address of the AP Change the password of the AP Management Tools Backup and Restore the Configuration SettingsPage Upgrade the Firmware for the Access Point Reboot the Access Point Troubleshooting Appendix a Specification Technical Support