OWNER’S MANUAL
CAST IRON STOVE AND
Continued
INSTALLING B-VENT BURNER SYSTEM INTO STOVE BODY
1.Carefully lift burner system and place into stove body from the rear of stove.
2.Place the left and right grate tops into the top of stove body. Discard center grate top of stove and replace with center grate top provided with burner system.
Center Top Grate (Included with Burner System)
Right Top Grate
Left Top
Grate
Burner
System
Cast Iron
Stove Body
Figure 15 - Installing Burner System Into Cast Iron Stove Body
INSTALLING OPTIONAL BLOWER ACCESSORY
NOTICE: If installing blower in an existing stove burner system with gas connections, shut off gas supply and disconnect heater from gas supply. Contact a quali- fied service person to do this.
1.Remove 4 hex screws securing rear cover to back of stove body (see Figure 16).
2.Separate bottom cover from rear cover by loosening the 8 mounting screws (see Figure 16).
3.Align the holes in the top mounting tabs of blower with the holes in wall of rear cover. Using the 4 screws provided, mount blower and tighten screws se- curely (see Figure 17).
4.Attach thermal switch and bracket to inside rear cover wall with two hex head screws provided as shown in Fig- ure 17. After securing bracket to rear
cover, carefully bend along existing bend line on bracket to almost a 90° angle (see Figure 17). This will allow thermal switch to be positioned against stove rear wall and sense temperature when in operating mode.
Hex Screws
Stove Body
Speed
Blower Control
Control Control
Knob Shaft
Locknut
TOP VIEW
Thermal Switch
and Bracket
Screws
Mounting
Holes
Blower |
|
Assembly | Mounting Holes |
Figure 17 - Blower Assembly, Speed Control, and Thermal Switch Locations
Rear Cover
Mounting
Screws
Hex
Screws
Mounting
Screws
Bottom Cover | Mounting |
Screws |
Figure 16 - Removing Rear Cover and Bottom Cover from Stove Body
Continued
106828 | 7 | For more information, visit www.desatech.com |
