® SBVBN(C) AND SBVBP(C)
CAST IRON STOVE AND BURNER SYSTEM
CAST IRON STOVE AND
Continued
9.Attach stove door by inserting step bolt through door hinge pivot hole and into threaded hole in stove body (see Fig- ure 11 and Figure 9 on page 5). Use an adjustable wrench or a 12mm socket to fasten step bolt. Tighten step bolt until snug. Make sure door moves freely.
Washers | Bottom Of | |
Bolt | Stove Unit | |
Leg | ||
|
Figure 10 - Attaching Stove Legs
Stove
Door
10.Install door catch bolt (M8 x 1.25- 55mm with two M8 hex nuts) into threaded hole on stove body (see Fig- ure 9, page 5). Use an adjustable wrench or a 12mm socket. The catch bolt has two hex nuts attached to it (see Figure 12). The top nut is a bolt stop and the bottom nut is for door leveling adjustment.
11.Check general catch bolt alignment with door claw. Make final adjustment and door leveling after stove is in nor- mal standing position.
12.Carefully lift stove back up on its four attached legs.
13.Remove 2 bolts from bottom of stove and discard. Remove bolt from the top of the stove to remove the front panel assembly (see Figure 13).
14.Lay the front panel assembly face down on a protected surface. Remove the two screws that hold the front plate onto the front surround plate (see Figure 14). Save these screws.
15.Remove the seven screws and washers that hold the screen onto the front sur- round plate. Discard these screws, washers, and screen. They are for vent- free use only (see Figure 14).
16.Replace the two screws from step 14 to reassemble the front plate and the front surround plate. Set this assembly aside until burner system has been in- stalled, logs have been placed inside of burner system, and glass door to burner system insert has been replaced.
Stove | Bolt | |
Body | ||
| ||
Front |
| |
Assembly |
|
Figure 13 - Removing Front Assembly
Screws
Front Surround
Plate
Screw with
Washer
Screen
Front Plate
Figure 14 - Removing Screen from Front
Threaded
Hole
Door
Hinge
Door Claw |
Door |
Bolt Stop
Adjusting Nut
Catch Bolt
Assembly
Step
Bolt
Bolt
Shoulder
Figure 11 - Attaching Stove Door
Figure 12 - Catch Bolt and Door Claw Orientation
For more information, visit www.desatech.com | 6 | 106828 |
