
Inventory
After all the parts have been removed from the two boxes, you should have the following items:
Jointer Box: (Figure 2) | Qty | |
A. | Jointer Assembly | 1 |
B. | Carriage | 1 |
C. | Fence | 1 |
D. | Extension Table | 1 |
E. | Push Blocks | 2 |
F. | Cutterhead Guard | 1 |
A
B
E
C
D
F
G
G.Tool Hardware Bag
1 Each | |
1 | |
H. Knife Setting Jig (not shown) | 1 |
Stand Box: (Figure 3) | Qty |
Figure 2. Box 1 inventory contents.
I
I. | Stand Assembly w/Motor | ........................... 1 |
J. | Pedestal Switch | 1 |
K. | Dust Port | 1 |
L. | Wheel Assembly | 1 |
M. | Belt Guard | 1 |
N. | 1 | |
Assembly Fasteners | Qty |
K
J
M
• Hex Bolt | 1 | |
• Flat Washer 8mm (Wheel/Stand) | 1 | |
• Hex Bolts | 2 | |
• | Flat Washers 10mm (Wheel/Stand) | 2 |
• | Hex Nuts | 2 |
•Cap Screws
• Lock Washers 8mm (Jointer/Stand) | 4 | |
• Flange Bolts | 2 | |
• Hex Nuts 6mm (Belt Guard) | 2 | |
• Flat Washers 6mm (Belt Guard) | 2 | |
• Cap Screws | (Fence) | 2 |
• Cap Screws | (Pedestal) | 2 |
• Lock Washers 8mm (Pedestal) | 2 | |
• Flat Washers 8mm (Pedestal) | 2 | |
• Phillips Screws | 4 | |
• Flat Washers 5mm (Dust Port) | 4 | |
• Cap Screws | (Carriage) | 2 |
• Flat Washers 10mm (Carriage) | 2 | |
• Cap Screws | 2 |
L | N |
Figure 3. Box 2 inventory contents.
In the event that any nonproprietary parts are missing (e.g. a nut or a washer), we would be glad to replace them, or for the sake of expedi- ency, replacements can be obtained at your local hardware store.
NOTICE
Some assembly fasteners may arrive pre- installed on the machine. Check the mount- ing locations on the machine before assum- ing that any items from the inventory list are missing.
G0604 6" X 56" Jointer |