Tighten the cap screws.
Figure 12. Installing extension table.
2. Use the straightedge to adjust the extension table flush with the infeed table.

When correctly set, the knife will barely touch

Extension Table

 

the straightedge, as shown in Figure 11.

 

—If your outfeed table is correctly set, no

 

 

 

 

Components and Hardware Needed:

Qty

adjustments are necessary.

 

Extension Table

1

—If the knife lifts the straightedge off the

Cap Screws M6-1 x 20

2

table or it is below the straightedge, then

To install the extension table:

 

the outfeed table must be reset. Refer to

 

Setting Outfeed Table Height on Page

1. Attach the extension table to the infeed table

38.

 

with the cap screws, as shown in Figure 12,

but do not fully tighten the cap screws yet.

������������

������� ������

Figure 11. Using a straightedge to align outfeed

table height with knife at TDC.

3.

-16-

G0604 6" X 56" Jointer

Page 18
Image 18
Grizzly G0604 owner manual Extension Table, To install the extension table, Setting Outfeed Table Height on