Fence, To install the fence | Grizzly G0604 guide

Fence
Components and Hardware Needed:	Qty
Carriage	1
Fence	1
Cap Screws M10-1.5 x 30	2
Flat Washers 10mm	2
Cap Screws M8-1.25 x 30	2
To install the fence:

1.Attach the fence carriage to the back of the table base (see Figure 13), but do not fully tighten the bolts yet.

Figure 13. Fence carriage installed.

2.Place a piece of paper on the table and slide the carriage over the table top to allow it to rest on the paper and self align, as shown in Figure 14, then tighten the carriage mounting bolts.

Note: The paper will keep the carriage from making direct contact with the table, which will keep the fence from dragging across the table when it is installed.

G0604 6" X 56" Jointer

Figure 14. Carriage slide propped up on paper.

3.Attach the fence to the carriage, as shown in Figure 15.

Figure 15. Attaching fence to carriage.

4.Install the tilt lever as shown in Figure 16.

Figure 16. Installing the fence tilt lever.

-17-

Image 19

Grizzly G0604 owner manual Fence, To install the fence

Contents

Model G0604 Page Table of Contents Warranty and Returns Foreword IntroductionContact Info Machine Data Sheet Identification Safety Instructions for Machinery Safety Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Jointers 110V Operation Circuit Requirements Unpacking SetupSetup Safety Items Needed for Setup Jointer Box Figure Qty Stand Assembly w/MotorAssembly Fasteners Qty Inventory Hardware Recognition Chart Components and Hardware Needed Qty CleanupWheel Assembly Site Considerations JointerV-Belt To install the V-beltTo mount the jointer to the stand To check the outfeed table height Checking Outfeed Table Height Setting Outfeed Table Height on To install the extension tableExtension Table Fence To install the fence Cutterhead Guard Pedestal SwitchTo install the cutterhead guard To install the pedestal switch Dust Port Knife Setting Jig Test Run Recommended Factory adjustments that should be verified Operations Operation Safety Basic ControlsStart & Stop Buttons Figure Tilt lock and plunger locations Stock Inspection and Requirements Squaring Stock Minimum dimensions for edge Jointing To surface plane on the jointer Surface Planing To edge joint on the jointer Edge Jointing To bevel cut on the jointer Bevel Cutting H9218-6 Byrd Shelix Cutterhead AccessoriesG3631-Jointer/Planer Knife Hone Dispoz-A-BladeHolder and Knife H1300 H1298 G7984 H2347 H0736 Our most popular safety glasses Lubrication MaintenanceBelt Cleaning Schedule Troubleshooting Guide Service Cutting Inspecting Knives Adjusting/Replacing KnivesTo inspect the knives Tools Needed Qty To adjust/replace the knivesPage To check the outfeed table parallelism Checking/Adjusting Table Parallelism To check the infeed table parallelism To adjust the table parallelism To set the outfeed table height Setting Outfeed Table Height Positive stop bolts for infeed table Setting Infeed Table To calibrate the depth scale Setting Fence StopsCalibrating Depth Scale To set the 45 outward fence stop To set the 90˚ fence stop Wiring Diagram Electrical Components Jointer Parts Breakdown Description Jointer Parts List Bumper Stand/Motor Parts Breakdown Stand/Motor Parts List PLABEL-29 Cutterhead Guard Label Warranty and Returns G0604 6 X 56 Jointer Comments Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage Call Today For a Free Full Color Catalog