Grizzly G0604 owner manual Test Run Recommended, Factory adjustments that should be verified

Test Run	Recommended
	Adjustments

Loose hair and cloth- ing could get caught in machinery and cause serious personal inju- ry. Keep loose clothing rolled up and long hair tied up and away from machinery.

Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses during assembly and operation.

Starting the machine:

1.Read the entire instruction manual first!

2.Make sure the cutterhead guard is installed and correctly adjusted (Page 18).

3.Make sure all tools and foreign objects have been removed from the machine.

4.Review SECTION 2 (Page 9) and connect your machine to the power source.

5.Turn the jointer ON.

—The jointer should run smoothly with little or no vibration.

—Immediately stop the jointer if you suspect any problems, and refer to Page 31 to troubleshoot/fix any problems before start- ing the jointer again.

—If you need any help with your jointer call our Tech Support at (570) 546-9663.

For your convenience, the adjustments listed below have been performed at the factory and no further setup is required to operate your machine.

However, because of the many variables involved with shipping, we recommend that you at least verify the following adjustments to ensure the best possible results from your new machine.

Step-by-step instructions for these adjustments can be found in SECTION 7: SERVICE.

Factory adjustments that should be verified:

1.Knife Height Settings (Page 33).

2.Table Parallelism (Page 36).

3.Outfeed Table Height Even w/Knives at Top Dead Center (Page 38).

4.Depth Scale Calibration (Page 40).

5.Fence Stop Accuracy (Page 40).

-20- G0604 6" X 56" Jointer