Grizzly G0604 owner manual Checking Outfeed Table Height, To check the outfeed table height

Cutterhead

Pulley

���������

Motor

Pulley

Figure 8. Pulleys aligned.

5.Remove the V-belt and loosen the motor mount fasteners.

6.Shift the motor horizontally as needed to align the motor pulley with the cutterhead pulley, then replace and retension the V-belt.

7.Tighten the motor mount fasteners.

8.Install the belt guard with the flange bolts, washers, and hex nuts (Figure 9).

9.Replace the access panel on the stand.

The belt guard MUST be installed before operating the jointer or the moving V-belt will be exposed, creating an entanglement hazard at the back of the jointer.

Belt

Guard

Figure 9. Installing belt guard.

G0604 6" X 56" Jointer

Checking Outfeed

Table Height

The outfeed table MUST be level with the knives when they are at top dead center (their highest point during rotation) or the workpiece cannot be fed across the jointer safely.

To check the outfeed table height:

1.Place a straightedge on the outfeed table so it extends over the cutterhead.

2.Rotate the cutterhead pulley until one of the knives is at top dead center, as illustrated in Figure 10.

��������

������

Figure 10. Cutterhead knife at top dead center.

-15-