JointerV-Belt

Components and Hardware Needed:

Qty

Jointer Assembly

1

Stand Assembly w/Motor

1

Cap Screws M8-1.25 x 25

4

Lock Washers 8mm

4

The jointer is heavy. Seek assistance when lifting it onto the jointer stand.

To mount the jointer to the stand:

1.Remove the rear cover from the jointer stand.

2.With the help of an assistant, lift the jointer onto the stand.

3.Align the mounting holes on the jointer and stand.

4.Secure the jointer to the stand with the cap screws and washers as shown in Figure 6.

Figure 6. Securing jointer to stand.

-14-

Components and Hardware Needed:

Qty

V-Belt

1

Belt Guard

1

Flange Bolts M6-1 x 12

2

Hex Nuts 6mm

2

Flat Washers 6mm

2

To install the V-belt:

 

1.Loosen the motor bracket fasteners shown in Figure 7.

Figure 7. Motor bracket fasteners (black arrows);

motor mount fasteners (white arrows).

2.Slide the motor upward and place the V-belt around the cutterhead pulley and the motor pulley.

3.Slide the motor down to tension the V-belt.

4.Visually check the alignment of the two pul- leys to make sure that they are aligned and that the V-belt is straight up and down (see Figure 8).

If the pulleys are aligned, tighten the motor bracket fasteners and go to Step 8.

If the pulleys are NOT aligned, perform Steps 5–7.

G0604 6" X 56" Jointer

Page 16
Image 16
Grizzly G0604 owner manual JointerV-Belt, To mount the jointer to the stand, To install the V-belt