Knife Setting Jig
Components and Hardware Needed: | Qty |
Knife Setting Jig Rod | 1 |
Knife Setting Jig Foot | 2 |
4 |
Assemble the knife setting jig as shown in Figure 19.
Figure 19. Knife setting jig assembly.
Dust Port |
|
Components and Hardware Needed: | Qty |
Dust Port | 1 |
Phillips Screws | 4 |
Flat Washers 5mm | 4 |
Install the dust port as shown in Figure 20.
Figure 20. Installing dust port.
DO NOT operate the Model G0604 with- out an adequate dust collection system. This machine creates substantial amounts of wood dust while operating. Failure to use a dust collection system can result in short and
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must take into account many variables, including the CFM rating of the dust collector, the length of hose between the dust collector and the machine, the amount of branches or wyes, and the amount of other open lines throughout the system. Explaining this cal- culation is beyond the scope of this manual. If you are unsure of your system, consult an expert or purchase a good dust collection
G0604 6" X 56" Jointer |
