Advantek Networks AWN-AP-54MR user manual

Page 13
Status
In this screen, you can see the current settings and status of this Access Point. You can change settings by selecting specific tab described in below.
System
System
UptimeThe time period since the device was up.
Firmware Version The current version of the firmware installed in this device.
Wireless Configuration
Wireless Mode There are four modes supported, Access Point, Client (Ad-hoc and Infrastructure), WDS Bridge and WDS repeater. The default mode is Access Point. If you want to change to bridge mode, please go to Wireless/WDS Setting to enable the WDS function.
10
Page 12 Page 14
Image 13
Page 12 Page 14
Contents 802.11b+g Access Point CE Mark Warning FCC RF Radiation Exposure StatementTable of Content Introduction FeaturesExample ApplicationLED Parts Names and FunctionsWEP/WP WDS ResetLAN LAN1Ssid Factory Default SettingsWEP Check the LEDs Hardware ConnectionWDS Repeater Mode Access Point ModeClient Mode Infrastructure WDS Bridge Mode Client Mode Ad-hocLogin ConfigurationPage Bssid StatisticsPage Basic Settings WirelessRate and 802.11g supported rate Advanced Settings Open System network Data. Upon receipt, the Access Point will respond 802.11g Protection IappSecurity WPA Tkip Radius Access ControlPage Clear all the select mark Dhcp BasicDhcp Page Other Upgrade FirmwareSave/Reload Settings Page System Log Password
Top Page Image Contents