ADTRAN DG834GV manual Testing the Path from Your Computer to a Remote Device, Request timed out

Page 28

Setup Manual for the DG834GV Integrated ADSL Modem and Wireless Router with Voice

Pinging <IP address> with 32 bytes of data

If the path is working, you see this message:

Reply from < IP address >: bytes=32 time=NN ms TTL=xxx

If the path is not working, you see this message:

Request timed out

If the path is not functioning correctly, you could have one of the following problems:

Wrong physical connections

Make sure the LAN port LED is on. If the LED is off, follow the instructions in “LAN or ADSL Internet Port LEDs Not On” on page 2-3.

Check that the corresponding Link LEDs are on for your network interface card and for the hub ports (if any) that are connected to your workstation and router.

Wrong network configuration

Verify that the Ethernet card driver software and TCP/IP software are both installed and configured on your PC or workstation.

Verify that the IP address for your router and your workstation are correct and that the addresses are on the same subnet.

Testing the Path from Your Computer to a Remote Device

After verifying that the LAN path works correctly, test the path from your PC to a remote device. From the Windows run menu, type:

PING -n 10 <IP address>

where <IP address> is the IP address of a remote device such as your ISP’s DNS server.

If the path is functioning correctly, replies as in the previous section are displayed. If you do not receive replies:

Check that your PC has the IP address of your router listed as the default gateway. If the IP configuration of your PC is assigned by DHCP, this information will not be visible in your PC’s Network Control Panel. Verify that the IP address of the router is listed as the TCP/IP default gateway as described in “Preparing a Computer for Network Access”.

Check to see that the network address of your PC (the portion of the IP address specified by the netmask) is different from the network address of the remote device.

If your ISP assigned a host name to your PC, enter that host name as the Account Name in the Basic Settings menu.

2-8

Troubleshooting

v1.1, April 2007

Image 28
Contents NETGEAR, Inc Trademarks Contents Using the Reset Button Chapter Connecting the Router to the Internet What’s in the Box?Adsl Modem Wireless Router with Voice’s Front Panel LED DescriptionsAdsl Modem Wireless Router with Voice’s Rear Panel V1.1, April Internet Configuration Requirements Two Setup Methods 1 Smart Wizard Setup 2 Manual SetupWhat You Need Before You Begin Smart Wizard Setup Manual Setup Understanding Adsl MicrofiltersManually Setting Up Your Adsl Modem Wireless Router Computers Set to DhcpV1.1, April Phone Port V1.1, April V1.1, April V1.1, April How to Set Up and Test Basic Wireless Connectivity Implement Appropriate Wireless Security How to Set Up and Test Basic VoIP Chapter Troubleshooting Basic FunctioningPower LED Not On Test LED Never Turns On or Test LED Stays OnTroubleshooting the Web Configuration Interface LAN or Adsl Internet Port LEDs Not OnTroubleshooting the ISP Connection Adsl link Obtaining an Internet IP Address Adsl Internet LED OffTroubleshooting PPPoE or PPPoA Troubleshooting Internet Browsing Troubleshooting a TCP/IP Network Using the Ping UtilityTesting the LAN Path to Your Router Testing the Path from Your Computer to a Remote Device Request timed outRestoring the Default Configuration and Password Using the Reset ButtonV1.1, April Appendix a Technical Specifications Network Protocol and Standards CompatibilityV1.1, April Appendix B Related Documents Document LinkV1.1, April