Allied Telesis AT-WR4600 manual Configuration example, Using QoS to prioritize voice traffic

Page 10

Configuration example

This configuration example starts with the Command Line Interface already set to Global configuration mode:

AT-WR4600#configure terminal

AT-WR4600(config)#

On setup completion, run the command show running-configto verify the applied configuration.

All of the examples in this document provide the minimum set of commands

Note: useful for configuring the WMM, regardless of other services like bridging, and security etc.

Using QoS to prioritize voice traffic

This example applies the QoS policy to support voice traffic.

Wireless nodes belong to a Wireless Distribution System working in 5GHz bands, while the access to a wireless LAN is offered in 2GHz bands.

10.0.0.0/24

AP

Bridge0

STA

Bridge2

STA AP

Bridge1

AP1

10.0.0.0/24

10.0.0.0/24

Figure 2 – QoS giving preference to voice traffic

Page 10 How To: Configure the WLAN with QoS

alliedtelesis.com

Page 9 Page 11
Image 10
Page 9 Page 11
Contents How To Configure the Wlan with QoS IntroductionTrademarks Following trademarks appear in this documentTable of contents Why use Wi-Fi Multimedia? What is Wi-Fi Multimedia WMMOverview How Wi-Fi Multimedia works WMM Access Categories and Ieee 802.1d tag mapping How to configure Wi-Fi Multimedia Parameter descriptionsConnecting AT-WR4600 products Accessing the device via SSHAccessing the CLI Configuration example Using QoS to prioritize voice trafficCommon setup Configure the common Ssid for open authenticationBridge0 station role root bridge Assign the static IP addressAT-WR4600config-if#ip address 10.0.0.1/24 Bridge2 station role non-root bridge
Top Page Image Contents