Symptom | Solutions |
|
|
While you are configuring the | To maintain wireless association, the service area and the |
access point, the Configuration | security settings on the client and the access point must |
Management System stops | match exactly. Therefore, if you are associated with the |
responding. | access point that you are configuring and you change the |
| access point service area or security, make sure to change the |
| client service area to match. |
| If you change the IP address and save the change, you cannot |
| continue to configure the access point using the old IP |
| address. Therefore, if you want to continue configuring this |
| access point after you save this change, you must do the |
| following: |
| 1 Close your browser. |
| 2 Return to the 3Com Device Manager Wireless Network |
| Tree and click Refresh. |
| 3 Select the access point and click Configure to start a new |
| configuration session. |
|
|
The access point cannot be | Reset the access point (push the reset button located near the |
configured using the Web | access point LEDs). |
browser. |
|
|
|
53