
3 TROUBLESHOOTING
If you have difficulty with the 3Com Wireless LAN access point, first check the following items in the configuration:
oRadio Settings page: Ensure that the SSID is the same on clients and the access point.
o
o
Security page: Ensure that Encryption is the same on clients and the access point.
Authentication page: Ensure that the Local MAC Authentication System Default is set to Allow. Ensure that 802.1x Authentication Settings are correct.
oTCP/IP Settings page: If the DHCP Client is set to Disabled, then ensure that the access point IP Address is within the same subnet as the wired LAN.
If necessary, reset the access point to the factory defaults.
Try the solutions in the following table. If you need further assistance, contact 3Com Technical Support through the following Web page: http://www.3com.com/products/en_US/supportedindex.jsp
Symptom | Solutions |
|
|
Access point does not | Make sure the Ethernet cable is plugged into the port labeled |
power up. | To Access Point on the power brick. |
| Check for a faulty access point power supply. |
| Check for a failed AC power supply |
|
|
Access point powers up, but | Make sure that the Ethernet cable is plugged into the port |
has no connection to the wired | labeled To Hub/Switch on the power brick. |
network. | Verify the network wiring and topology for proper |
| |
| configuration. Check that the cables used are the proper type. |
51