3Com WL-455 manual Flat Surface Installation

Page 26

3Connect the power cable to power port on the rear panel of the access point.

4Position the access point at an angle to the mounting plate bayonet connection and turn the unit clockwise until it snaps into place, as shown below.

FLAT SURFACE INSTALLATION

The access point can also be placed on a flat surface such as a table, desktop or filing cabinet. Do not install the access point on any type of metal surface. If you choose a flat surface mount, select a location that is clear of obstructions and provides good reception.

Note: Regulatory restrictions dictate that when this device is operational, the minimal body-to-antenna distance is 1 Meter (3 Feet).

20

Image 26

Contents

Wireless LAN Access Point Campus Drive Contents System Configuration Troubleshooting Regulatory Compliance Information Index Page Product Features SecurityPerformance and Reliability „ HTTP/HTTPSWDS Bridging and Spanning Tree Protocol STP Support 802.11G Wireless Network Standard ManageabilityInfrastructure Wireless LAN Standard Network Configuration and PlanningAD HOC Wireless LAN Infrastructure Wireless LAN for Roaming Wireless PCS Advanced Network Configuration and Planning PUBLIC/PRIVATE Access Point ServiceTerminology Page Page Installing the Access Point Installation RequirementsPower Requirements Safety InformationDeciding Where to Place Equipment Performing a Site Survey Before YOU Begin Connecting the Standard Antennas Connecting Power Using the Included AC AdapterUsing AN Optional POWER-OVER Ethernet Injector Mounting on a Wall Using a POWER-OVER-ETHERNET LAN PortChecking the Leds Plastic anchors and 3 screws Flat Surface Installation Selecting and Connecting a Different Antenna Model Power Settings on the Access Point for External Antennas USAInstalling Software Utilities European CommunityPage Using the 3COM Wireless Device Manager Launching a Wireless Device ConfigurationClick Configure Using the PRE-IP Configuration Wizard Configuration LoginSetting the Country Code Basic Setup Dhcp Client Advanced SetupIdentification WEB Servers Smart MonitorRadius Page Authentication „ 802.1x Supplicant Setup ParameterDescription Enabling Vlan Filtering Filter ControlFiltering by Vlan Uplink Port MAC Address Filtering Client List TimeoutSecurity Filters Filtering by Ethernet Protocol Type Snmp Trap Configuration Trap Description When the Trap is SentSnmp Users Dot1xMacAddrAuthSuccessGroups Snmp Targets Snmp FilterAdministration WDS/STP Settings Bridge Address Entry Configuration GuidelinesRadio Bridge Roles Configuring Spanning Tree Protocol Settings Scanning for WDS LinksLink Configuration System LOGStatus Enabling Virtual Access Point VAP Radio SettingsVirtual Access Point VAP Configuration Radio InterfacePage Changing Radio Settings Page Configuring Encryption Selecting a Virtual Access Point VAPConfiguring Authentication SecurityWPA Configuration WEP Configuration HOW to Setup the Access Point for Radius Authentication Select Advanced SetupSelect Advanced Setup HOW to Setup the Access Point for WPA with PRE-SHAREDPSK KEYWPA Configuration for Windows XP WPA-PSK Tkip Page Troubleshooting SymptomSolutions Access point that you are configuring and you change Page Regulatory Compliance Information Industry Canada Emissions Compliance Statement EU Compliance Grundlegenden Anforderungen und den anderen EU Restrictions for Use in the 2.4GHz band Page Index Page TCP/IP