Power supply
Note
•When playing a voice/music file, the recorder may be reset due to the reduction of the voltage output of the
batteries depending on the volume level even if [º] is displayed in the battery indicator. In this case, lower the volume of the recorder.
Charging by connecting to a computer via USB
You can charge the batteries by connecting to a PC’s USB port. When charging, be sure to correctly place the rechargeable batteries (supplied) into the recorder (☞ P.15).
Before connecting the USB cable, exit HOLD mode (☞ P.21).
Do not charge primary batteries such as alkaline or lithium batteries. It may cause battery leakage or heating, which may cause the recorder to malfunction.
1Boot the PC.
2Connect the USB cable to the USB port of the PC.
3While the recorder is during stop mode or turned off, connect the USB cable to the connecting terminal on the bottom of the recorder.
4Press the `OK button to start charging.
•While [Press OK to start charging] is flashing, press the `OK button.
5Charging is completed when battery indication becomes to [¿].
Charging time: approximately 3 hours *
*It shows the approximate time when charging the rechargeable battery fully from no remaining power at the room temperature. The charging time
1
Power supply
EN
17