Olympus LS-7 manual Press the REC s button again, Settings relating to Recording, Pause

Page 32

Recording

2

Recording

EN

Settings relating to Recording

[Mic Select]

Select whether or not the

built-in center microphone is

(☞ P.50)

to be turned On or Off.

 

[Mic Sense]

Sets the recording sensitivity.

(☞ P.50)

 

[Rec Mode]

Sets the recording rate for

(☞ P.51)

each recording format.

[Rec Level]

You can configure whether

to adjust the recording level

(☞ P.51)

automatically or to adjust it

 

manually.

[Zoom Mic]

Sets the directivity of the

(☞ P.52)

builtin stereo microphone.

[Low Cut Filter]

This function can reduce

noise from air conditioners,

(☞ P.52)

projectors and other similar

 

noises.

[VCVA]

Sets the threshold level for

the Variable Control Voice

(☞ P.53)

Actuator (VCVA).

 

[V-Sync. Rec]

Sets the start level for voice

(☞ P.54)

sync recording.

[Timer Rec]

Sets timer recording.

(☞ P.67)

 

[Rec Scene]

Sets the recording settings

which matches the recording

(☞ P.55)

condition or environment.

 

[Rec Monitor]

Select whether or not to

output the recording monitor

(☞ P.55)

sound from the EAR jack.

 

 

 

 

Select whether or not to use

[Plug-inPower]

the plug-in power function

according to the external

(☞ P.56)

microphone connected to

 

 

the MIC jack.

 

 

[Pre-Recording]

Pre-recording enables you

to start recording up to 2

(☞ P.56)

seconds before you press the

 

button for recording.

Pause

While the recorder is during recording mode, press the REC (s) button.

•[≠] will appear on the display.

•The recorder will time out after 120 minutes when left in [Rec Pause].

Resume Recording:

Press the REC (s) button again.

•Recording will resume at the point of interruption.

To quickly check on the recorded contents

While the recorder is during recording mode, press the `OK button.

•[•] will appear on the display.

•Recording will stop, and the file that was just recorded will be played back.

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents LS-7 Introduction Trademarks and registered trademarksTable of contents Safety precautions Safety precautions Handling the recorderBe careful with the strap Keep young children and infants away from the recorderBattery handling precautions Keep battery out of the reach of childrenSafety precautions Main features Getting startedMain features Main featuresChecking the contents of the box Identification of parts = POWER/HOLD switch QBattery cover wUSB connectorPeak indicator light LED LED indicator light LED Recorder mode display 1Recording media indicatorDisplay LCD panel Identification of partsMusic mode display 1Recording media indicator# Playback position bar indicator $Icon display P.14 Identification of partsIdentification of parts Icon displayFor all modes Power supply Close the battery coverInserting batteries Direction BBattery settings SettingComplete the setting Recorder P.15Power supply Charging by connecting to a computer via USBAdapter optional to charge Plug the recorder’s USB cableInto the AC adapter Plug the AC adapter into AC outletOperating temperature BatteriesDischarging Storage for a long period -20C 30C/ -4F 86FTurning on/off the power Turning on the powerTurning off the power Power save modeSlide the POWER/HOLD switch to Set the recorder to Hold mode Exit Hold modeSlide the POWER/HOLD switch to Hold position ApositionSetting time and date Time & Date Press the 9or 0button to Select the item to setSetting time and date Time & Date Changing the time and dateInserting and ejecting a microSD card Inserting a microSD cardInserting and ejecting a microSD card Close the card cover securelyInserting and ejecting a microSD card Ejecting a microSD cardPress the List button repeatedly to set the Home display Press the + or − button to select the modeHome display operations About the folders for voice recordings About the folder for music playback FoldersFirst layer Second layer FolderFileSelecting the folders and files Recording Press the REC s button to start recordingSelect the recording folder Press the REC s button to prepare recordingRecording Press the Stop 4 button to Stop recordingRecording It is possible to record exceeding 2GBSettings relating to Recording To quickly check on the recorded contentsPress the REC s button again PauseChanging the recording scene Rec Scene Connect the earphone to the EAR jack on the recorderPress the + or − button to select Rec Scene Recording Listening while audio is recordedRecommended settings by recording condition Recording Recommended settingsLS7 0001 .MP3 ConditionRecording from external microphone or other devices Applicable external microphones optional P.96Recording the sound of other devices with this recorder Recording the sound of this recorder with other devicesVolume can be adjusted within a PlaybackRange from 00 to Stop 4 button + − button `OK buttonPlayback through earphone Settings relating to playbackPlayback While Hold the 9button Hold the 0button9button While the recorder is duringPlayback mode, press While the recorder is during stopAbout the limits of fast playback Noise Cancel P.57Changing the playback speed F2 Index button 90button Erase button Setting an index mark or a temp markClearing an index mark or a temp mark F1 A-B button How to begin segment repeat playbackRepeat playback Canceling the segment repeat playback Function Changing the playback scene Play SceneBPress the Stop 4 button CPress the 9buttonErasing a folder ErasingErasing files Play the file you want to partially erase ErasingPartially erasing a file When Partial erase completed. is Press the Erase buttonPress the + or − button to change the setting Menu setting methodMenu setting method Setting menu during playback Close the menu screen Menu setting methodSetting menu during recording + File Menu Rec MenuAdjust the recording level Select the recording formatSelect the recording rate Select Manual or AutoAbout the Zoom Mic function Zoom MicLow Cut Filter 300HzAdjust the start/stop actuation level Select On/Off or Standby Sets the Vcva functionAdjust the voice sync level Press the 9or 0button to adjust the voice sync levelSelect On or Off Sets the detection timeWhen Scene Save is selected When Scene Select is selected Select a recording sceneSet the recording settings according to your preferences Select Scene Select or Scene SaveHow to enable pre-recording Plug-inPowerPress the REC s button Pre-RecordingVoice Filter Noise CancelPlay Menu Select Forward Skip or Reverse Skip Set the skip space Select the desired playback mode Select Repeat or RandomForward/Reverse Skip Playback When Scene Select is selected Select a playback scene Set the playback settings according to your preferencesPlay Scene ReverbSelect Lighting Time or Brightness Select the setting LCD/Sound MenuMenu settings after resetting initial settings Device MenuMemory Info System InfoFormat Rearranging files Replace Press the F2 Exit button to close the menu screenPress the + or − button to select the file you want to move F2 button + − button `OK buttonPress the `OK button to move to the respective setting Moving/Copying files File Move/CopyWhen you select 1file When you select Selected filesWhen you select All files Press the F2 GO buttonPress the F2 Exit button to complete the setting Dividing files File DivideStop playback at the divide position Press the + button to select Start Press the `OK buttonTimer recording Timer Rec Select Timer Rec from the menu on the Rec MenuOn/Off setting Day settingTime setting Rec Mode settingFolder setting Mic Sense settingVolume, Alarm Sound and Playback File Alarm playback function AlarmSelect Alarm from the menu on the Play Menu Press the `OK button to move to the respective setting Start Time settingVolume setting Alarm Sound settingSelect the folder using the + or Select Voice Guide from the menu in LCD/Sound Menu Speed settingGuidance Voice Guide Changing the USB class USB Settings Select USB Settings from the menu on the Device MenuWhen USB Connect is selected When USB Class is selectedFormatting the recorder Format Method Select Format from the menu on the Device MenuSetting method MenuSetting MethodOperating environment WindowsPrecautions on using the recorder connected to a PC Operating environmentMacintosh Operating System DisplaySonority Using Olympus SonorityFunctions available in the Olympus Sonority Using Olympus Sonority Installing softwareChanging the Installation Destination Using Olympus SonorityUninstalling software Using Olympus SonorityExit Olympus Sonority Select Control Panel from Start menu Exit Olympus SonorityCopying voice guide data Connect the recorder to a PCStart Olympus Sonority Copy voice guide dataUpgrade function Start the Olympus SonorityOr click the button in the Tool Bar Select Purchase Olympus Sonority Plus in the Help MenuFunctions available in the Olympus Sonority Plus Functions available with the music editing plug-inSearch by keyword Using online helpSearch by contents Connecting to your PC Connecting to your PCWindows MacintoshData will be destroyed Connecting to your PCDisconnecting from your PC Transfer the voice files to your PC Using as external memory of the PC Using as external memory of the PCMessage Meaning Explanation Action Alarm message listAlarm message list Can’t make System file. ConnectTo PC and delete Unnecessary fileTroubleshooting TroubleshootingSymptom Probable cause Action Troubleshooting Troubleshooting Symptom Probable cause ActionUnable to set index Marks, temp marksCannot recharge RecorderAccessories optional Specifications Specifications During recording mode Built-in microphoneDuring playback mode During recording mode Microphone jackGuide to battery life Recording mode Built-in stereo microphone Earphone playbackDuring playback mode Alkaline batteries100 Linear PCM formatMP3 format WMA format101 Linear PCM formatCanadian RFI Technical assistance and supportDeclaration of Conformity Olympus Imaging Corp
Top Page Image Contents