Magnavox VRZ242AT owner manual Setting Up the VCR Plus+ Programming System cont’d

Now, compare the channel numbers you have written in the VCR PLUS+ CH. and CABLE/TV CH. columns. For stations whose VCR Plus+ and Cable/TV channels do not match, you must tell the VCR the VCR Plus+ and Cable/TV channel numbers by following steps 3 - 7. Make each entry within 60 seconds of the previous entry.

3

Press the VCR button, then press the MENU button.

4

Press the PLAY/o button or the STOP/p button to select VCR SET UP, then press the F.FWD/B button.

SELECT op CHOOSE B

→ REPEAT PLAY OFF

ON SCREEN MODE LANGUAGE

VCR PLUS+ REF. MAP

TO END PUSH EXIT

5

Press the PLAY/o button or the STOP/p button to select VCR PLUS+ REF. MAP, then press the F.FWD/B button.

4-5

6

Look at the lists you filled in on page 34. For stations whose

VCR Plus+ and Cable/TV channels do not match, press the PLAY/o button or the STOP/p button until the arrow is beside the VCR Plus+ channel you need. Then, press the Number buttons to enter the corresponding Cable/TV channel from your list. (Enter a “0” before single- digit channels.) Enter all the stations on your list.

VCR PLUS+ CROSS REF. MAP

9898

9999

1– – – – –> 23

22

TO SELECT CH PUSH op

THEN ENTER CH NO.

TO END PUSH EXIT

7

Press the STATUS/EXIT button.

Helpful Hints

•To erase a Cable/TV channel num- ber, repeat steps 3-5 on this page. Then, press the PLAY/o button or the STOP/p button to select it.

Press the CLEAR button, then press the STATUS/EXIT button.

•To select line input for the Cable/TV channel, press 0,0. AUX will appear on-screen.

•When you receive the VCR, all the VCR Plus+ channel numbers and Cable/TV channel numbers are the same.