Magnavox VRZ242AT owner manual Timer Recording With the VCR Plus+ Programming System cont’d

5

Press the Number 1 button to record in SP speed, the Number 2 button to record in LP speed, or the Number 3 button to record in SLP speed. Your selection will appear beside REC SPEED on-screen; SP=1 LP=2 SLP=3 will continue to flash. For details about tape speed, see pages 32 and 46. You can- not use the SPEED button at this time.

ONE TIME PROGRAM

TO END PUSH EXIT

6

Press the STATUS/EXIT button. PROGRAM WAS COM-

PLETED / PLEASE TURN OFF VCR FOR TIMER RECORDING should appear on-screen briefly.

7

Press the POWER button to turn off the VCR power. The Timer light will appear. The Timer light will flash if there is not a tape in the VCR.

If the timer recording will take place several hours or days from now, you may use the VCR until time for the recording. Just turn off the VCR a few minutes before the recording starts. If you for- get to turn off the VCR, PLEASE TURN OFF VCR FOR TIMER RECORDING flashes on your TV screen two minutes before a timer recording starts. Remove the message by pressing the CLEAR button.

7

5

6

0+100

The VCR must be off for a

timer recording to take

place! Make sure there is a

tape in the VCR.

Helpful Hints

•If the time for a timer recording comes up during a One-Touch Recording, the OTR has priority.

•To stop a started timer recording, press the STOP/EJECT button on the VCR.

•If the power fails for more than one minute, programmed timer record- ings may be lost. Reset the clock before resetting the timer record- ings.

•If you are using a Cable Box, timer recordings are programmed differ- ently. See page eight for details.

See page 44 for more hints.