quency, then press PROG. The channel number appears.
2.Use the number keys and • (MON/CLR) to enter the frequency (including the decimal point) you want to store.
3.Press E (SVC) to store the frequency into the chan- nel.
Notes:
•If you entered an invalid frequency in Step 2, Error appears and the scanner beeps three times. Enter a valid frequency.
•The scanner automatically rounds the entered number to the nearest valid frequency. For exam- ple, if you enter 151.473 (MHz), your scanner accepts it as 151.475.
Press DELAY to pause scanning 2 seconds after the end of a transmission before scanning proceeds to the next channel (see “Delay” on Page 31). The scanner stores this setting in the channel.
4.To program the next channel in sequence, press PROG and repeat Steps 2 and 3.
SEARCHING FOR AND TEMPORARILY STORING ACTIVE FREQUENCIES
If you do not have a reference to frequencies in your ar- ea, use a limit, direct, or service search (except weather service search) to find a transmission. Also see “Guide to the Action Bands” on Page 59.
Note: While doing a limit, direct, or service bank search, press:
•DELAY if you want the scanner to pause 2 seconds after a transmission ends before it proceeds to the next frequency (see “Delay” on Page 31).
•DATA if you want the scanner to skip data signals (such as fax or modem signals) and search only for
Operation25