Compaq EXS Series, EX Series manual Installing a GPA/AIMM Card

Page 50

Installing a GPA/AIMM Card

WARNING: Power is continuous to the system board and power supply even when the power switch is turned off. To prevent damage to the unit, disconnect the power cord from the power source or the unit before beginning disassembly procedures.

1.Prepare the computer for disassembly (Section 4.2).

2.Lay the computer down on its large base for greater stability.

3.Remove the access panel (Section 4.5).

4.Insert the hook 1 on the left side of the GPA/AIMM card under the loop 2 on the left side of the retention mechanism.

5.Rotate the right side of the card down until it is at a 45 degree angle 3.

Compaq Deskpro EX and Deskpro EXS Series of Personal Computers 4-23

Image 50

Contents Maintenance & Service Guide Maintenance & Service Guide Maintenance & Service Guide Contents Removal and Replacement Procedures Specifications Technician Notes Symbols and ConventionsAbout this Guide Locating Additional Information Chapter Product DescriptionComponent/Function Computer FeaturesFront Panel Controls and LEDs Rear Panel Connectors ComponentReference Drive Bay Configuration Drive PositionsSerial Number Location Spare Parts Spare Part Warranty Description Number Tier System UnitMass Storage Devices Cables Standard, Memory, and Expansion Boards Miscellaneous Plastics Kit Keyboards not illustrated Miscellaneous Screw Kit not illustratedDocumentation and Software not illustrated Miscellaneous Parts not illustratedShipping Boxes not illustrated Description Spare Part NumberGenerating Static Removal & Replacement PreliminariesElectrostatic Discharge Information Relative Humidity Event 55% 40% 10%Grounding Workstations Preventing Electrostatic Damage to EquipmentPersonal Grounding Methods and Equipment Method VoltageRecommended Materials and Equipment General Cleaning Safety PrecautionsRoutine Care Cleaning the Monitor Cleaning the Computer CaseCleaning the Keyboard Power Supply Fan Service ConsiderationsCleaning the Mouse Tools and Software RequirementsHard Drives Cables and ConnectorsLithium Coin Cell Battery Removal and Replacement Procedures Disassembly Sequence ChartDisassembly Preparation Feet Installation Cable Lock Access Panel Front Bezel Power Button Subpanel and Bezel Blanks Power Switch Assembly Drive Positions Using the Cable-Select Feature with Ultra ATA Devices Removing an Internal 3.5-Inch Hard Drive Removing an External 5.25-Inch Drive Removing an External 3.5-Inch Drive Page Expansion Boards Expansion Board SlotsRemoving a PCI Expansion Board Installing a PCI Expansion Board Page DIMMs Memory Module InstallationSystem Memory Page Graphics Cards Installing a GPA/AIMM Card 24Removal & Replacement Procedures AGP Card with a Type I Retention Mechanism Removing an AGP Card13.3 GPA/AIMM Card with a Type 2 Retention Mechanism AGP Card with a Type 2 Retention Mechanism Standard AGP Expansion Card Processor 30Removal & Replacement Procedures System Board Battery Chassis Fan Assembly Power Supply Connectors and Jumpers Connectors and JumpersClearing Cmos Disabling or Clearing the Power-On and Setup Passwords Definition Seagate Quantum Western Digital Hard Drive Jumper SettingsSeagate, Quantum, and Western Digital Maxtor Definition J50 J48 J46 J44 J42System SpecificationsSpecifications Hardware IRQ System Function System InterruptsSystem DMA Hardware DMA System FunctionICH Fixed I/O Registers Port Register NameICH Fixed I/O Registers Port Register Name System Memory Map Size Memory Address System FunctionDrives MB Diskette DriveUltra ATA Hard Drives 10.0 GB 15.0 GBCD-ROM Drives 48X MaxCompaq Keyboard Scroll MouseIntel 3D Graphics Supported Graphics ResolutionsColor Depth Mode Bits/pixel Refresh Rate Hz NVIDIA M64 ProIndex 2Index