Acnodes PC 6170 manual Hard Disk Boot Priority, Virus Warning, CPU L1 & L2 Cache

Page 49

PC 6170 User’s Manual

Hard Disk Boot Priority

This item can select boot device priority.

Virus Warning

This option flashes on the screen. During and after the system boot up, any attempt to write to the boot sector or partition table of the hard disk drive will halt the system with the following message. You can run an anti-virus program to locate the problem. The default setting is Disabled.

! WARNING !

Disk boot sector is to be modified

Type “Y” to accept write or “N” to abort write

Award Software, Inc.

Enabled

Activates automatically when the system boots up

 

causing a warning message to appear when there is an

 

 

attempt to access the boot sector or hard disk partition

 

 

table.

 

Disabled

No warning message will appear when attempts to

 

 

access the boot sector or hard disk partition table are

 

 

made.

 

 

 

NOTE: This function is only available with DOS and other operating systems that do not trap INT13.

CPU L1 & L2 Cache

These two options speed up memory access. However, it depends on the CPU/chipset design. The default setting is Enabled. CPUs with no built-in internal cache will not provide the CPU Internal Cacheitem on the menu.

Enabled

Enable cache

Disabled

Disable cache

Quick Power On Self Test

This option speeds up Power on Self Test (POST) after you turn on the system power. If set as Enabled, BIOS will shorten or skip some check items during POST. The default setting is Enabled.

 

Enabled

Enable Quick POST

 

 

Disabled

Normal POST

 

 

 

 

 

SBC83810 BIOS Setup

41

Image 49 Contents
Pentium-M Panel PC Disclaimers FCC Compliance Safety ApprovalsSafety Precautions Trademarks Acknowledgments This page does not contain any information Table of Contents Embedded O.S. Installation Introduction Front Access USB Ports & OSDGeneral Description Most Reliable and Stable Design-Intel Pentium M ProcessorEasy-to-Maintenance Design Back Door SpecificationsMain CPU board „ Standard I/O System„ 17 TFT LCD „ Disk drive housing System SpecificationDimensions Front View Front View and I/O OutletsVGA 2 I/O OutletPackage list CPU and Dram Installation Hardware InstallationDram CPU HDD Installation User’s Manual CD-ROM Installation Put the CD-ROM in the drive bracket and fix it by 6 screws Add-on Card Installation Parallel Port 3 x Serial PortsVGA Ethernet RJ-45 Connector Pin AssignmentVESA-ARM Mountings Panel/Wall/Desktop/VESA/RackWall Mount PC 6170 User’s Manual Desktop Kit Assembly Fix two holders by 2 screws Complete Panel-mount Kit Assembly Rack mounting Assembly System Driver InstallationTouch Screen SpecificationDriver Installation- Windows 98/2000/XP/CE.NET/XP-Embedded PC 6170 User’s Manual Identify the communication port and IRQ number Driver Installation- DOSDo Calibration Install PenMount driver Driver Installation- LinuxSet COM3 as touch Dual LAN This page does not contain any information Windows XP Embedded Embedded O.S. InstallationPenmount Touch Screen Calibration Touch Screen Windows CE.NET Standard Cmos Setup Menu SBC83810 Bios SetupTime DateHalt On Drive a type/Drive B typeScsi Advanced Bios FeaturesQuick Power On Self Test Hard Disk Boot PriorityVirus Warning CPU L1 & L2 CacheBoot Other Device First/Second/Third Boot DeviceBoot Up Floppy Seek Boot Up NumLock StatusTypematic Delay Msec Typematic Rate SettingTypematic Rate Chars/Sec OS Select for Dram 64MB Security OptionReport No FDD For Win Dram Data Integrity Mode Advanced Chipset FeaturesSdram CAS latency Time Video Bios Cacheable System Bios CacheableDelayed Transaction Video RAM CacheableIntegrated Peripherals SPP Power on Function IDE HDD Block ModeIDE Primary/Secondary Master/Slave PIO IDE Primary/Secondary Master/Slave UdmaParallel Port Mode UART2 Duplex ModeOnboard FDC Controller Onboard Serial Port 1/PortECP Mode Use DMA S1POS Power Management SetupAcpi Function Power ManagementPM Control by APM Video Off MethodStandby Mode Doze ModeSuspend Mode Video Off AfterPower On by Ring HDD Power DownThrottle Duty Cycle VGA Active MonitorReload Global Timer Events PNP OS Installed PnP/PCI Configuration SetupReset Configuration Data IRQ Resources Resources Controlled ByDMA Resources Memory ResourcesPC Health Status Current CPU TemperatureCurrent FAN1/FAN2 Speed Auto Detect DIMM/PCI Clk Frequency/Voltage ControlSpeed Spectrum Cmos Setup Utility-Copyright Award Software Load Fail-Safe DefaultsLoad Optimized Defaults Y/N? N Load Optimized DefaultsPower Supply FSP180-50PLA1 180W, AC 110~230V Input Power Supply SpecificationHOLD-UP Time @FULL Load Short Circuit Protection Efficiency Shock