PC 6170 User’s Manual
1/2/4/6/8/10/20/ 30/40 Min/1 Hr
Defines the continuous idle time before the system entering SUSPEND mode.
If any item defined in (J) is enabled & active, SUSPEND timer will be reloaded
HDD Power Down
After the selected period of drive inactivity (1 to 15 minutes), the hard disk drive powers down while all other devices remain active. The default value is “Disabled”.
Disabled | HDD’s motor will not power OFF. |
1/2/3/4/5/6/7/8/ | Defines the continuous HDD idle time before |
9/10/11/12/13/1 | the HDD enters power saving mode (motor OFF) |
4/15 Min |
|
Throttle Duty Cycle
When the system enters Doze mode, the CPU clock runs only part of the time. You may select the percent of time that the clock runs. The default value is “62.5%”.
VGA Active Monitor
When Enabled, any video activity restarts the global timer for Standby mode. The default value is “Enabled”.
Soft-Off by PWR-BTTN
This option only works with systems using an ATX power supply. It also allows the user to define which type of soft power OFF sequence the system will follow. The default value is
| This option follows the conventional manner systems |
| perform when power is turned OFF. |
power OFF sequence requiring only the switching of the | |
| power supply button to OFF |
| Upon turning OFF system from the power switch, this |
Delay 4 Sec. | option will delay the complete system power OFF |
sequence by approximately 4 seconds. Within this | |
| delay period, system will temporarily enter into |
| Suspend Mode enabling you to restart the system at |
| once. |
Power On by Ring
This option allows the system to resume or wake up upon detecting any ring signals coming from an installed modem. The default value is “Enabled”.
IRQ 8 Break Suspend
You can turn on or off monitoring of IRQ8 (the Real Time Clock) so it
SBC83810 BIOS Setup | 55 |