Metrologic Instruments MS9530 Series manual Linking the Voyager RF to the Base Station

Page 7

LINKING THE VOYAGER RF TO THE BASE STATION

This section explains how to link the Voyager RF to the Base Station. It is supposed that the software is already loaded into the unit and that the Base Station is configured with its own serial number.

Power ON the Base Station

Insert Battery Pack and press CodeGate button to power ON the unit.

Voyager will show its ID number by keeping RED and GREEN LEDs on while flashing YELLOW on as many times as the ID value ( 1 to 5 )

Voyager will try several attempts to link with Base Station. Every try will make the Red LED flashing.

If no Link is performed, an error beep will sound. In this case press Code Gate button to continue. Otherwise, if link is performed the scanner will operate normally.

Read Enter/Exit Configuration Mode barcode

Read the Recall Defaults barcode (MetroSelect Single Line Voyager Configuration guide) to default Voyager parameters.

Read the RF Defaults barcode to default RF engine

MS9530 Voyager RF

7

Printed: September 2002

Version: 1.1

 

Status: Approved

Image 7
Contents MS9530 Series Voyager RF Programming Modes MetroSet Software Version EML Handshaking Timeout SpecificationsEML Product Overview Base Station Unpacking List RS232 Interface Connecting the Base Station to the Host Wedge InterfaceLight PEN and Ocia Interfaces Linking the Voyager RF to the Base Station Read Enter/Exit Configuration Mode barcodeRead Enter/Exit Configuration Mode barcode Fixing Voyager RF ID Numbers MS9530 Voyager RF Printed September Version Status Approved Base Station Testing Barcode RED Green Battery PackMS9530 Voyager RF Printed September Version Status Approved Data Transmission Sequence Visual IndicatorsStart Up Sequence Synchronisation SequenceLow Battery Message Programing Modes MetroSet Software Version EML EML Handshaking TimeoutSpecifications subject to change without notice Specifications RF Link SpecificationsElectrical