Troubleshooting Guide

MULTI-TASKER

24. [G]

This command is used to request group data. With the command, the user can identify which input or output of a particular group is on.

Command Format: [GkUi]

Gk = group number (k = # from 1-9)

Ui = unit number (i = # from 0-9)

Example:

In unit ID0, if group 1 has DA Cards with outputs 1 and 2 on, while group 2 has SW Cards with input 2 on:

[G1]: will return feedback as ON12 G1U0.

[G2]: will return feedback as ON2 G2U0.

25. [RD]

This command displays the members in each group.

Command Format: [RDGkUi]

Gk = group number (k = # from 1-9)

Ui = unit number (i = # from 0-9)

member = C1 - C19 (card 1 to 19)

(1-8 for MT100-101 or 1-4 for MT100-106)

Example:

The cards in slots 1, 2 and 19 are part of group 5 in unit 1. Read the member data for group 5 of unit 1, by sending the command [RDG5U1]. The system will return feedback as follows:

C1C2C19 G5U1.

7.3 SUMMARY OF COMMANDS

1)	[VER]	Receives software version
2)	[Ci]	Receives status of the card
3)	[CLR]	Resets card to defaults
4)	[ + ]	Increments and Decrements
	[ - ]	selected commands
5)	[HPOS]	Set the Horizontal Position
6)	[HPOS]	Adjust/Read Horiz. Position

7)	[VPOS]	Set the Vertical Position
8)	[VPOS]	Adjust/Read Vert. Position
9)	[HSIZE]	Set the Horizontal Size
10)	[HSIZE]	Adjust/Read Horizontal Size
11)	[VSIZE]	Set the Vertical Size
12)	[VSIZE]	Adjust/Read the Vertical Size

13)[QZOOM] Zoom to a quadrant

14)[QZOOM] Adjust Zoom by quadrant

15)	[BRIG]	Set Brightness level
16)	[BRIG]	Adjust/Read Brightness
17)	[SHARP]	Set Sharpness level
18)	[SHARP]	Adjust/Read Sharpness
19)	[OUT]	Select NTSC or PAL format
20)	[BAR]	Video or test pattern
21)	[HELP]	Display available commands
22)	[WR]	Group multiple cards
23)	[CLR]	Clear group configurations
24)	[G]	Request group data
25)	[RD]	Display group members

We have carefully tested and have found no problems in the supplied MT106-100; however, we would like to offer suggestions for the following:

8.1 LED IS NOT LIT

Cause 1: Card cage is not plugged in.

Solution: Plug card cage in. If the LED lights, the problem is solved. If the LED is still not ON, see Cause 2.

Cause 2: Card is not plugged in all the way.

Solution: Push the card in all the way. If the LED is still not ON, see Cause 3.