Clevo D900F Installing the VGA Card, Disassembly, Removing the VGA Card 2, VGA Card Installation

Installing the VGA Card

1. Prepare to fit the VGA card 24 into the slot by holding it at about a 30° angle.

2.The card needs to be fully into the slot, and the VGA card and socket have a guide-key and pin which align to allow the card to fit securely.

3.Fit the connectors firmly into the socket, straight and evenly.

4.DO NOT attempt to push one end of the card in ahead of the other.

5.The card’s pin alignment will allow it to only fit one way. Make sure the module is seated as far into the socket as it will go (none of the gold colored contact should be showing). DO NOT FORCE the card; it should fit without much pressure.

6.Secure the card with screw 22 & 23 (Figure 12f on page 2 - 16).

7. Place the heatsink 24 back on the card, and secure the screws in the order indicated in Figure 11 on page 2 - 15.

8.Attach the VGA card fan and secure with the screws as indicated in Figure 11 on page 2 - 15.

9.Reinsert the component bay cover, and secure with the screws as indicated in Figure 11 on page 2 - 15.

a.

25

Disassembly

Figure 13

VGA Card

Installation

a. Carefully Insert the VGA Card.

2.Disassembly



24. VGA card Module

Removing the VGA Card 2 - 17