Ampro Corporation PCI-104 quick start Msdat, Msclk

Page 35

Appendix B								I/O Interface Board
Table B-9.			Mouse Interface Pin/Signal Descriptions (J9B)

		J9B			Signal	From Onboard		Description
		Pin #				Connector & Pin #
		1			MSDAT	J4-31		Mouse Data
		2, 4			NC	NA		Not connected

		3			GND	J5-37		Ground
		5			KBVCC	J5-38		Mouse Power (+5V +/-5%) – Provided through shared
								Fuse (F1) to mouse voltage pin.
		6			MSCLK	J4-32		Mouse Clock

	Note: The shaded area denotes power or ground.
Table B-10.			SMBus Interface Pin/Signal Descriptions (J10)

		J10			Signal	From Onboard		Description
		Pin #				Connector & Pin #
	1				SMB_Clk	J5-22		System Management Bus Clock
	2				SMB_Data	J5-16		System Management Bus Data

	3				SMB_Alert	J5-10		System Management Bus Alert

	4				VCC	J5-38		+5 volts +/-5%
	5				GND	NA		Ground

Note: The shaded area denotes power or ground.

CoreModule 800

QuickStart Guide

31

Image 35

Contents CoreModule PCI-104 Single Board Computer QuickStart Guide Audience Assumptions Contents Table A-1 CD-ROM Setting Up the CoreModuleRequirements What’s in the BoxPreparation Setting Up the WorkspaceCoreModule 800 Connector Locations Connecting Cables to the CoreModuleSkip any steps that do not apply to your situation Refer to the CoreModule 800 I/O Interface Design Library on Cable Connecting Boot Devices Connecting PeripheralsApplying Power to the CoreModule Connecting the Power SupplyMain Advanced PCIPnP Boot Boot Device Priority Default Jumper # Installed Removed/EnabledGND Wire Color Four Pin # Ten Pin # SignalQuickStart Guide CoreModule Removing the Sodimm Installing CoreModule 800 OptionsInstallation Guidelines Tools RequiredDDR Sodimm Removing Sodimm from Socket Installing the SodimmRetaining Latches Angle KeyHidden Pressing down on Sodimm Installing Software, Drivers, and Utilities Chapter QuickStart Guide CoreModule Method Contact Information Appendix a Technical SupportAppendix a Interface Board Layout Appendix B Interface BoardSignal Pin # On Description Board Interface Board ConnectorsDTR1 RTS1TXD1 CTS1Signal OnBoard Description Pin # BSY PD7ACK DS1Figure B-2. RS-485 Serial Port Implementation Signal From Description Pin # Onboard ConnectorSignal From Description Pin # Onboard DB9 Connector Signal From Onboard Description Pin # Connector & Pin # Msclk J10 Signal From Onboard Description Pin # Connector & Pin #Msdat Pin # Signal Description Init BusySlct ALFComponent Description Miscellaneous ComponentsConnector Pin Number Manufacturer Manufacturer’s PN Appendix C Connector Part NumbersConnector Pin Number Mfg Manufacturer’s PN Appendix C