9.Remove the three screws holding the keyboard support plate then remove the plate.
10.Remove the screw fastening the modem board.
11.Disconnect bluetooth antenna.
NOTE: This is an engineering sample. The number of screws holding the keyboard support plate maybe vary from the mass production units.
12.Disconnect the modem board cable then remove the modem board.
13.Pull out the wireless antenna from the hole on the main board.
14.Remove the four screws fastening the LCD module; two on the front and another two on the back.
15.Place the LCD module as the picture shows carefully.
16.Disconnect the LCD coaxial cable and inverter cable respectively.
Chapter 3 | 53 |