Siemens manual HC15-DSB75 adapter board switch settings

Page 30

Getting Started with HC15

Confidential / Preliminary

s

5 Appendix II

This chapter refers to the DSB75 Board and the adapter board needed to mount a HC15 module onto the DSB75 Board.

The focus is on the configuration of several switches you may be required to change for use with HC15. A detailed description of the DSB75 Board is given in [3].

Please check that all slide switches (S100 – S103) on your HC15-DSB75 adapter board are set as shown in Figure 3.

80-pin header

X106, X107: Do not use

X104: 50-pin board-to-board connector for HC15

Figure 3: HC15-DSB75 adapter board – switch settings

Figure 4 shows the DSB75 Board and provides an overview of the connectors and switches relevant for HC15. Please note that the factory settings of the DSB75 Board are not fully applicable to HC15. The switches marked red or yellow must be set as shown. The switches marked green need not be changed.

HC15_startup_v01

Page 30 of 31

2007-01-22

Image 30

Contents User’s Guide Getting Started with HC15 Getting Started with HC15Contents FiguresIntroduction Related DocumentsInstallation and Configuration Technical Requirements for Running HC15 on DSB75Getting Started with HC15 Installing the Hardware Getting Started with HC15 Installing USB and Ethernet Drivers Getting Started with HC15 Next Installed Devices and Tools Siemens Hsdpa USB ModemUninstalling Drivers and the Connection Manager Siemens Wireless Ethernet AdapterSiemens USB Com Port Uninstalling Drivers and Tools from Earlier HC15 Releases Uninstalling Earlier DriversUninstalling Earlier Connection Manager Using the HC15 Module AT Command InterpreterSwitching on the HC15 Switching off the HC15Registering to the Network Selecting Umts or GSM Attaching to the Hsdpa or Gprs Network Defining the PDP ContextMaking a Voice Call MO Answering a Voice Call MTHsdpa or Gprs Data Transfer Hsdpa or Gprs Data Transfer via Dial-Up Network Terminating the dial-up connection Adding and Configuring a New Dial-Up Connection AppendixAdding a New Dial-up Connection Getting Started with HC15 Getting Started with HC15 Configuring a Dial-up Connection Getting Started with HC15 Most cases, it is sufficient to accept the default settings Abbreviations Abbreviation DescriptionHC15-DSB75 adapter board switch settings Do not use X201, X202