Siemens HC15 manual Uninstalling Drivers and the Connection Manager, Siemens USB Com Port

Page 13

Getting Started with HC15

Confidential / Preliminary

s

Siemens USB Com Port

•AT command interface, also referred to as “Application” port if queried using the AT^SQPORT command.

•Mainly intended for controlling the HC15 module, for receiving URCs, can be used also for sending, receiving, writing and reading short messages. Not intended as data interface for HSDPA and GPRS.

•The virtual COM port Windows has assigned to this port is listed in the Device Manager under Ports (COM&LPT).

Siemens Wireless Ethernet Adapter

•Wireless network adapter intended for HSDPA and GPRS data connections.

•Listed in the Device Manager under Network adapters.

•Software controlled by the Siemens Connection Manager. To open the program in Windows XP, click Start, point to Programs, select Siemens, select HSDPA USB Modem and click Connection Manager. See chapters 3.10 and 3.10.1 for details of how to set up a connection.

2.6Uninstalling Drivers and the Connection Manager

Select Control Panel -> Add or Remove Programs and Connection Manager

Press Remove to select the uninstaller of the Connection Manager and the HC15 drivers.

Please press Yes to start the uninstaller.

The Connection Manager and all HC15 drivers will be removed.

HC15_startup_v01

Page 13 of 31

2007-01-22

Page 12 Page 14
Image 13
Page 12 Page 14
Contents User’s Guide Getting Started with HC15 Getting Started with HC15Figures ContentsRelated Documents IntroductionTechnical Requirements for Running HC15 on DSB75 Installation and ConfigurationGetting Started with HC15 Installing the Hardware Getting Started with HC15 Installing USB and Ethernet Drivers Getting Started with HC15 Next Siemens Hsdpa USB Modem Installed Devices and ToolsSiemens Wireless Ethernet Adapter Uninstalling Drivers and the Connection ManagerSiemens USB Com Port Uninstalling Earlier Drivers Uninstalling Drivers and Tools from Earlier HC15 ReleasesUninstalling Earlier Connection Manager AT Command Interpreter Using the HC15 ModuleSwitching off the HC15 Switching on the HC15Registering to the Network Selecting Umts or GSM Defining the PDP Context Attaching to the Hsdpa or Gprs NetworkAnswering a Voice Call MT Making a Voice Call MOHsdpa or Gprs Data Transfer Hsdpa or Gprs Data Transfer via Dial-Up Network Terminating the dial-up connection Appendix Adding and Configuring a New Dial-Up ConnectionAdding a New Dial-up Connection Getting Started with HC15 Getting Started with HC15 Configuring a Dial-up Connection Getting Started with HC15 Most cases, it is sufficient to accept the default settings Abbreviation Description AbbreviationsHC15-DSB75 adapter board switch settings Do not use X201, X202
Top Page Image Contents