Behringer SNR2000 manual Operation of the expander section

Page 12

DENOISER SNR2000

2.2.4 AUTO switch

The AUTO switch allows to automatically control release time and cut off frequency of the TAC filter. Thus, by depressing the AUTO switch, the RELEASE and CUT OFF controls are deactivated. Release time and cut off frequency of the filter are now automatically derived from the input signal.

Generally, good results will be achieved with the AUTO function. However, with complex sound sources e.g. classical music featuring a great amount of disturbing noise fine tuning should be done with the RELEASE and CUT OFF controls.

2.2.5 FREQUENCY meter

A precise 8-digit LED meter indicates the current operating point of the filter. The LEDs keep you informed regarding lower cut off frequency, release time and frequency range of the audio signal. If no LED lights up, the cut off frequency is set to 800 Hz. If, on the other hand, all LEDs light up, the bandwidth is above 20 kHz and the filter has no influence on the usable signal.

It proves quite useful to set the SENSITIVITY control in that way that the noise floor causes the first LEDs to light up.

+Please note that this meter is merely supposed to help you adjust the controls. It is re- commended to perform A/B comparisons with the FILTER IN/OUT switch to find out which setting suits your demands!

+Please also note that after power-up the unit needs a few minutes to warm up. While the unit calibrates automatically, the LEDs might indicate values that deviate from the values stated by the controls and scales on the front panel!

2.3 Operation of the expander section

The noise reduction system of the DENOISER is based on two signal processing techniques, which can be used separately but may also be combined with each other: in addition to the dynamically controlled low-pass filter mentioned above, the DENOISER features a so-called downward expander which uses a second noise reduction process to eliminate remaining interference noise.

A downward expander automatically reduces the overall level for all signals below an adjustable threshold and therefore extends the dynamic range of the program material.

Changing the variable release time and the expansion ratio enables the expander to operate as a noise gate. Expanders generally function with a flat ratio curve, so that the signal continually fades. Noise gates however, can be seen as a special type of expander. They normally work with a more exaggerated ratio and radically attenuate the signal if it falls below the threshold.

+The following explanations also apply to the gate function, because the gate is a special form of the expander.

12

2. OPERATION

Image 12
Contents User’s Manual Safety Instructions Detailed Safety InstructionsForeword Denoiser Table of Contents Introduction Design conceptBefore you begin Control elementsFront panel control elements Operation Operation of the filter sectionTAC filter of the Denoiser Operation of the dynamic filterDenoiser SNR2000 Operation of the expander section IRC expander of the Denoiser Function of an expanderDenoiser SNR2000 Initial settings of the Denoiser ApplicationsCouple function We recommend the following control settings Studio applicationsNoise reduction during recording Noise reduction in the effects bus Noise reduction on keyboards Technical Background What are audio dynamics?Compressors/limiters Expanders/noise gatesDownward expansion Noise as physical phenomenonCompanders Installation Single-ended principleRack mounting Audio connectionsSpecifications THD Warranty § 1 Warranty CARD/ONLINE Registration § 2 Warranty